PDB Series 260 W Programmable LED Drivers

By ERP Power 85

PDB Series 260 W Programmable LED Drivers

ERP Power's PDB series programmable LED drivers are targeted for deployment in area, floodlight, parking garage, roadway, tunnel, and other outdoor lighting fixtures. In a typical street lighting application, a single ERP driver can replace market alternatives that require two drivers. The ERP single-driver approach requires up to 60% less space at less than one half the cost. Constant current output is high-efficiency and fully programmable from 150 W to 260 W in a wide range of output currents and voltages while maintaining efficiency of 93% from 50% to 100% of load. ERP drivers are designed in California and built to last with a 5-year limited warranty.

Features
  • Programmable:
    • Current: 100% to 50% in each voltage range
    • Output voltage range selection
    • Datalog read: SKU, S/N, lot code, hours of operation, FW rev., fault events: power failure, transients (short or surge), thermal events
  • Non-linear 0 V to10 V dimming profile with dim-to-off (10 V to 9.1 V = 100%, 1.5 V to 0.6 V = 1%, <0.6 V = dim-to-off)
  • Auxiliary output 12 V/100 mA
  • Dual output voltage range
  • IP66-rated case with silicone-based potting
  • Surge protection:
    • Combination wave IEC61000-4-5: 4 kV line-to-line/4 kV line-to-earth (higher surge is available upon request)
    • 2.5 kV ring wave: ANSI/IEEE c62.41.1-2002 and c62.41.2-2002 category A
  • 90°C maximum case hot spot temperature
  • Complies with ENERGY STAR® luminaire specification and Design Light Consortium® (DLC) technical requirements
  • UL Class P
  • Worldwide safety approvals
Applications
 
  • Area lighting
  • Commercial lighting
  • High bay applications
 
  • Horticulture applications
  • Outdoor LED lights
  • Street lights

Categories

Top