Vishay's NZC power phototriac have a trigger current of 10 mA, on-state current of up to 1ARMS, which complement the existing broad phototriac offering.
By Vishay Semiconductor / Opto Division 543
The ultra-low power 10 MBd ACPL-061L-000E optically coupled optocoupler combines an AlGaAs LED and an integrated high gain photo detector.
By Broadcom Limited 145
The ACPL-M21L optically-coupled logic gate has CMOS output stage and optical receiver input stage with built-in Schmitt trigger.
By Broadcom Limited 120
Microchip's MCP2210 evaluation kit is a development and evaluation platform for the MCP2210 device.
By Microchip Technology 164
Linear Technology's LTC6362 low power, low noise differential op amp with rail-to-rail input and output swing has been optimized to drive low power SAR ADCs.
By Analog Devices Inc 136
ams' AS8510 is a low noise, 2 channel measurement device featuring control signals for external high side PGA including zero offset architecture.
By ams 134
AMC1204BDC delta-sigma modulators from TI are a single chip solution for measuring current shunt signals in an isolated barrier.
By Texas Instruments 126
Linear Technology's LT4275 is a pin-for-pin compatible family of IEEE 802.3 and LTPoE++ powered device (PD) controllers.
By Analog Devices Inc 130
Holt Integrated Circuits' HI-3110 demonstrates CAN filters, masks, and SPI clock frequency selectable from 625 KHz – 20 MHz.
By Holt Integrated Circuits Inc 129
LMP91050/51 design kits are easy-to-use and simplify the evauation and design-in of TI's LMP91050/1 configurable AFE.
By Texas Instruments 157
FTDl's FT311D USB Android host IC allows designers to bridge an interface on their peripheral hardware to an Android tablet or smartphone platform over the Android USB device port.
By FTDI, Future Technology Devices International Ltd 91
FTDl's FT312D is a USB 2.0, full-speed host IC targeted at providing access to peripheral hardware from an Android platform with a USB device port.
By FTDI, Future Technology Devices International Ltd 130
FTDI's FT232H USB2.0 is a single-channel USB-to-UART/FIFO interface device can be configured via EEPROM to use a variety of different serial or parallel interfaces.
By FTDI, Future Technology Devices International Ltd 92
Ideal for low noise instrumentation systems by providing amplification before 24-bit delta sigma ADCs.
By Renesas 152
SY88149HAL 1.25 Gbps burst-mode capable, limiting-post amplifier from Microchip generates a high-gain LVTTL LOS or SD output and is available in a 16-pin QFN package.
By Microchip Technology 80
NXP Semiconductors introduces logic plastic packages. The ultra-compact packaging design is ideal for leading-edge portable handheld devices.
By NXP Semiconductors 110
TI's ISO154 series is made up of low-power, bi-directional isolators that are I²C interface compatible.
By Texas Instruments 102
Output expanders have a wide VCC range of 1.65 - 3.6 V, making it an ideal solution for portable applications.
By Texas Instruments 81
TCA6416A series of I/O expanders have a wide VCC range allowing it to interface with next-generation microprocesors and MCUs on the SDA/SCL side.
By Texas Instruments 107
I/O expanders have an operating power-supply range of 1.65 V to 3.6 V, making them well-suited for providing general-purpose remote I/O expansion.
By Texas Instruments 419