TS9013SCW RPG

It was two months, in the mailbox delivery, the board with the marked is very pleasing but the tracks are thin when soldering one that goes to the microphone cracked at r1 did not immediately find. And the foil is straight thin on soldering once. The generation was able to start but the microphone does not work properly, it is possible that modulation is not fm and am is going, tried to measure the frequency at compressed turns of 92 mhz when the 102-107 mhz open. I gave a signal from the low-frequency generator the level floats apparently because of the capacitor c3 must probably be replaced with a resistor. The frequency of unstable swims should be fixed with hot melt or paraffin better turns. I found many schemes of similar but there are differences, there are no c6 and c3. While dancing with a tambourine, the receiver at this frequency with an am range does not check for nothing modulation. On the microphone, too, the board is flawed so that it is ideally included in it, it is the wrong polarity to bend the conclusions to get up well.I found a similar scheme but with changes i lay out, maybe it is more literate.