XCR3064XL 64 Macrocell CPLD
10 www.xilinx.com DS017 (v2.4) September 15, 2008
Product Specification
Warranty Disclaimer
THESE PRODUCTS ARE SUBJECT TO THE TERMS OF THE XILINX LIMITED WARRANTY WHICH CAN BE VIEWED
AT http://www.xilinx.com/warranty.htm
. THIS LIMITED WARRANTY DOES NOT EXTEND TO ANY USE OF THE
PRODUCTS IN AN APPLICATION OR ENVIRONMENT THAT IS NOT WITHIN THE SPECIFICATIONS STATED ON THE
THEN-CURRENT XILINX DATA SHEET FOR THE PRODUCTS. PRODUCTS ARE NOT DESIGNED TO BE FAIL-SAFE
AND ARE NOT WARRANTED FOR USE IN APPLICATIONS THAT POSE A RISK OF PHYSICAL HARM OR LOSS OF
LIFE. USE OF PRODUCTS IN SUCH APPLICATIONS IS FULLY AT THE RISK OF CUSTOMER SUBJECT TO
APPLICABLE LAWS AND REGULATIONS.
Additional Information
CoolRunner XPLA3 CPLD Data Sheets and Application
Notes
Device Packages
Device Package User Guide
Revision History
The following table shows the revision history for this document.
Date Version Revision
06/01/00 1.0 Initial Xilinx release.
08/30/00 1.1 Added 48-ball CS BGA package.
11/18/00 1.2 Updated to full production data sheet; corrected note in Ta bl e 4 to read: "port enable pin is
brought High".
12/08/00 1.3 Added PC44 package.
04/11/01 1.4 Added Typical I/V curve, Figure 2; added Ta b l e 2 : Total User I/O; changed V
OH
spec.
04/19/01 1.5 Updated Typical I/V curve, Figure 2: added voltage levels.
01/08/02 1.6 Moved I
CC
vs. Freq Figure 1 and Ta ble 1 to page 1. Added single p-term setup time (T
SU1
)
to AC Table, renamed T
SU
to T
SU2
for setup time through the OR array. Updated T
SUF
and
T
FIN
spec to match software timing. Added T
INIT
spec. Updated T
CONFIG
spec. Updated T
HI
spec to correct a typo. Updated AC Load Circuit diagram to more closely resemble true test
conditions, added note for T
POD
delay measurement. Updated note 5 in AC Characteristics
table lowering typical current draw during configuration.
04/02/02 1.7 Updated the following specs based on characterization of product after move to UMC
fabrication: V
OH
, F
SYSTEM
, T
PCO
(added T
PTCK
parameter), T
F
, and T
LOGI3
. Added typical
leakage current note to DC table. Also updated Typical I
CC
vs. Frequency and Derating
Curve for T
PD2
(improved to 5.4 ns for 16 outputs switching) per new characterization data.
01/27/03 1.8 Corrected typical I
CC
vs. Frequency (Figure 1) and Derating Curve for T
PD2
(Figure 4).
Updated F
MAX
for -6 speed, I
CC
@ f=1 MHz based on characterization of product after move
to UMC fabrication. Updated Ordering Information format.
07/15/03 1.9 Updated Device Part Marking. Updated test conditions for I
IL
and I
IH
.
08/21/03 2.0 Updated Package Device Marking Pin 1 orientation.
02/13/04 2.1 Add soldering temperature. Add links to application notes and data sheets and packages.
04/08/05 2.2 Added I
CCSB
Typical and T
APRPW
specifications. Removed T
SOL
specification.
03/31/06 2.3 Added Warranty Disclaimer. Added Pb-Free information to ordering table.
09/15/08 2.4 Added notes to Table 2 , Ta b l e 3 and Table 4 to indicate the PC44 package is obsolete.
Removed part number references to the obsolete PC44C and PCG44C packages in the
Ordering Combination Information. See Product Discontinuation Notice
xcn07022.pdf.
