ICS1894-43
10BASE-T/100BASE-TX INTEGRATED PHYCEIVER WITH RMII INTERFACE PHYCEIVER
IDT®
10BASE-T/100BASE-TX INTEGRATED PHYCEIVER WITH RMII INTERFACE 26
ICS1894-43 REV A 030112
Note 1: Ignored if Auto negotiation is enabled.
Note 2: CW = Command Override Write
LH = Latching High
LL = Latching Low
LMX = Latching Maximum
RO = Read Only
RW = Read/Write
RW/0 = Read/Write Zero
RW/1 = Read/Write One
SC = Self-clearing
SF = Special Functions
Note 3: L = Latched on power-up/hardware reset
† As per the IEEE Std 802.3u, during any write operation to any bit in this register, the STA must write the default value to all Reserved bits.
Register 25 - Extended Control Register
25.15:12 Reserved
Reserved
RW 0 0
25.11 Reserved
Reserved
RW 0 6
25.10 Add_Bias Disable Enable RW 1
25.9 TX10BIAS_SET The normal output current of the Bias block for
10BaseT is 540uA. Changing the register can modify
the current with a step size of 5%
000: output 80% current
001: output 85% current
010: output 90% current
011: output 95% current
100: output 100% current
101: output 105% current
110: output 110% current
111: output 115% current
RW 1
25.8 0
25.7 04
25.6 TX100BIAS_SET The normal output current of the Bias block for
100BaseTX is 180uA. Changing the register can
modify the current with a step size of 5%
000: output 80% current
001: output 85% current
010: output 90% current
011: output 95% current
100: output 100% current
101: output 105% current
110: output 110% current
111: output 115% current
RW 1
25.5 0
25.4 0
25.3 OUTDLY_CTL This register controls the delay time of the digital
control signal for xmit_dac.
00: Longest delay time (same as original design)
01: Long delay time
10: Short delay time
11: Shortest delay time
RW 0 1
25.2
25.1 RX_SET The output current of Bias block for RX block is
108µA. The register can change the current with a
step about 16.5%
00: Output 83.5% current
01: Output 100% current
10: Output 116.5% current
11: Output 133% current
Changing this value may modify the RX block
performance
RW 0
25.0 1
Register
26 - 31 - Extended Control Register (Reserved)
Bit Definition When Bit = 0 When Bit = 1 Access
2
SF
2
Default
3
Hex
