MAX4524/MAX4525
Low-Voltage, Single-Supply
Multiplexer and Switch
2 _______________________________________________________________________________________
ABSOLUTE MAXIMUM RATINGS
ELECTRICAL CHARACTERISTICS—Single +5V Supply
(V+ = 4.5V to 5.5V, GND = 0V, V
AH
= 2.4V, V
AL
= 0.8V, T
A
= T
MIN
to T
MAX
, unless otherwise noted. Typical values are at
T
A
= +25°C.) (Notes 2, 7)
Stresses beyond those listed under “Absolute Maximum Ratings” may cause permanent damage to the device. These are stress ratings only, and functional
operation of the device at these or any other conditions beyond those indicated in the operational sections of the specifications is not implied. Exposure to
absolute maximum rating conditions for extended periods may affect device reliability.
(Voltages Referenced to GND)
V+ ..............................................................................-0.3V, +13V
Voltage into any terminal (Note 1) ................-0.3V to (V+ + 0.3V)
Continuous Current into any Terminal ..............................±20mA
Peak Current, NO, NC or COM_
(pulsed at 1ms,10% duty cycle)....................................±40mA
ESD per Method 3015.7 ..................................................>2000V
Continuous Power Dissipation (T
A
= +70°C)
10-Pin µMAX (derate 4.1mW/°C above +70°C) ............330mW
10-Pin TDFN (derate 24.4mW/°C above +70°C) ........1951mW
Operating Temperature Ranges
MAX452_C_ _ ......................................................0°C to +70°C
MAX452_E_ _....................................................-40°C to +85°C
Storage Temperature Range .............................-65°C to +150°C
V
A
= V
INH
= 2.4V
V+ = 4.5V, I
COM
= 1mA, V
COM
= 3.5V
V+ = 5.5V; I
COM
= 1mA;
V
COM
= 1.5V, 2.5V, 3.5V
V
A
= V
INH
= 0.8V
CONDITIONS
µA-1 +1I
IH
Input Current Low
90 150
VV- V+
V
COM
,
V
NO
Analog Signal Range
µA-1 +1I
IH
Input Current High
Ω
210
∆R
ON
COM-NO/NC On-Resistance
Match Between Channels
(Note 3)
Ω512R
FLAT
COM-NO/NC On-Resistance
Flatness (Note 4)
-1 +1
-2 +2
UNITS
MIN TYP MAX
(Note 2)
SYMBOLPARAMETER
Note 1: Voltages exceeding V+ or GND on any signal terminal are clamped by internal diodes. Limit forward-diode current to max-
imum current rating.
V0.8 1.5V
IL
Logic Input Logic
Threshold Low
V+ = 5.5V; V
NO
= 1V, 4.5V; V
COM
= 4.5V, 1V nA
-10 +10
I
NO(OFF),
I
NC(OFF),
NO/NC Off-Leakage
(Note 5)
+25°C
C, E
C, E
+25°C
+25°C
+25°C
+25°C
C, E
TEMP
C, E
C, E
V+ = 4.5V, I
COM
= 1mA, V
COM
= 3.5V
C, E
Ω
200
R
ON
COM-NO/NC On-Resistance
C, E
-50 +50C, E
V+ = 5.5V; V
NO
= 1V, 4.5V;
V
COM
= 4.5V, 1V
nA
-25 +25
I
COM(OFF)
COM Off-Leakage
(Note 5)
C, E
-1 +1+25°C
MAX4524
MAX4525
MAX4524
MAX4525
-50 +50C, E
V+ = 5.5V; V
COM
= 4.5V, 1V nA
-25 +25
I
COM(ON)
COM On-Leakage
(Note 5)
C, E
-1 +1+25°C
-2 +2+25°C
15
V1.5 2.4V
IH
Logic Input Logic
Threshold High
C, E
ANALOG SWITCH
DIGITAL I/O
