Continued from the preceding page.
http://www.murata.com/
Data Sheet
!
Note:
1. This datasheet is downloaded from the website of Murata Manufacturing co., ltd. Therefore, it’s specifications are subject to change or our
products in it may be discontinued without advance notice. Please check with our sales representatives or product engineers before ordering.
2. This datasheet has only typical specifications because there is no space for detailed specifications. Therefore, please approve our product
specifications or transact the approval sheet for product specifications before ordering.
2
o This data sheet is applied for CHIP COMMON MODE CHOKE COIL used for General Electronics equipment for your design.
2011.5.12
Noise Suppression Products/EMI Suppression Filters > Common Mode Choke Coil > Wire Wound Type for Large Current
Part Number
Common Mode Impedance
(at 100MHz/20°C)
Rated Current Rated Voltage Insulation Resistance (min.) Withstand Voltage DC Resistance
Operating
Temperature Range
DLW5BSN152SQ2p
1500ohm (Typ.) 1000mA 50Vdc 10M ohm 125Vdc 0.1ohm max. -40 to +85°C
DLW5BSN302SQ2p
3000ohm (Typ.) 500mA 50Vdc 10M ohm 125Vdc 0.3ohm max. -40 to +85°C
4.5
4.75
5
0 1020304050607080
75°C85°C
90 100
Rated Current (A)
Operating Temperature (°C)
DLW5BSN191SQ2 Temperature Derating
Number of Circuit: 1
■ Derating of Rated Current
!Caution (Rating)
Do not use products beyond the rated current and
rated voltage as this may create excessive heat
and deteriorate the insulation resistance.
Notice
Solderability of Tin plating termination chip might be
deteriorated when low temperature soldering profile
where peak solder temperature is below the Tin melting
point is used. Please confirm the solderability of Tin
plating termination chip before use.
■ !Caution/Notice