RAD-RS485-IFS
106318_en_02 PHOENIX CONTACT 14 / 19
7.7 Copying device settings to new network
devices
Figure 9 Configuration with memory stick
1 Memory stick
2 Status LEDs
3 SET button
Your individual configuration data can be saved to a memory
stick (RAD-MEMORY, see accessories in the "Ordering
data" section on page 3), e.g.,to transfer the same
configuration to other devices.
Common network parameters:
– Data rate of the RS-485 interface
Individual device parameters:
– Station name
–RAD ID
Writing a full copy of the individual device parameters
and common network parameters to the memory stick
(RAD-MEMORY):
• Press and hold down the SET button on the front
module for at least six seconds. The LINK LED starts
flashing.
• Insert the memory stick in the S-PORT of the front
module.
• The copying of parameters is started automatically.
• Wait until the LINK LED is no longer flashing. The write
process has been completed.
• Remove the memory stick from the front module.
Reading in common network parameters via the
memory stick:
This function enables common network parameters to be
read in from the memory stick. This means that all network
devices can have the same network parameters.
• Insert the memory stick in the S-PORT of the front
module.
• Press and hold down the SET button on the front
module for one second.
• Parameter read in is started.
• Read-in has been completed when the DAT LED lights
up once. The new parameters are activated.
• Remove the memory stick from the front module.
Reading in a full copy of the individual device
parameters and common network parameters via the
memory stick:
This function enables all individual device parameters and
common network parameters to be read in from the memory
stick. This means that a full copy of devices can be created.
This can be used, forexample, to create a backup copy of a
device for device replacement.
• Insert the memory stick in the S-PORT of the front
module.
• Press and hold down the SET button on the front
module for at least six seconds. The LINK LED starts
flashing.
• Parameter read in is started, the DAT LED flashes.
• Wait until the DAT LED is no longer flashing. The read-
in has been completed. The new parameters are
activated.
• Remove the memory stick from the front module.
WARNING: Explosion hazard when used
in potentially explosive areas
Do not insert or remove the memory stick in a
potentially explosive atmosphere.
If an error is detected while saving or
subsequently checking the data, the DAT and
ERR LEDs flash simultaneously.
+24V
0V
+24V
COM
1
NO
1
NC
1
D(A) D(B)
SET
RAD-ID
RAD-RS485-IFS
S.PORT
8
8
PWR
DAT
ERR
RX
LIN
K
TX
0V
SET
3
2
1