深圳市海盛电池有限公司
Shenzhen Hypercell Company Limited
Page 1 0 o f 1 2
7.Security Testing Standard(Single Cell)
Item Battery Condition Test Method Requirements
Crush
Fresh,
Full charged
Crush between two flat plates. Applied force is
about 13kN(1.72Mpa) for 30min.
No explosion,
No fire
Short
Circuit
20
Fresh,
Full charged
Each test sample battery, in turn, is to be short-
circuited by connecting the (+) and (-) terminals of
the battery with a Cu wire having a maximum
resistance load of 0.1.Tests are to be conducted
at room temperature(20±2 ).
No explosion,
No fire,
The Temperature
of the surface of
the cells are
lower than 150
Short
Circuit
60
Fresh,
Full charged
Each test sample battery, in turn, is to be short-
circuited by connecting the (+) and (-) terminals of
the battery with a Cu wire having a maximum
resistance load of 0.1.Tests are to be conducted
at temperature(60±2 ).
No explosion,
No fire,
The temperature
of the surface of
the cells are
lower than 150
Impact
Fresh,
Full charged
A 56mm diameter bar is inlayed into the bottom of
a 10kg weight. And the weight is to be dropped
from a height of 1m onto a sample battery and
then the bar will be across the center of the
sample.
No explosion,
No fire
Forced
Discharge
Fresh,
Full charged
Discharge at a current of 1C
5
mA for 2.5h.
No explosion,
No fire
Nail
Pricking
(3mm)
Fresh,
Full charged
Prick through the sample battery with a nail having
a diameter of 3mm and remain 2h.
No explosion,
No fire
深圳市海盛电池有限公司
Shenzhen Hypercell Company Limited
Page 1 1 o f 1 2
8. Storage and Transportation
8.1 Storage:
8.1.1 The Li-ion battery pack should be stored in a cool, dry and well-ventilated area, and should be far
from the fire and the high temperature.
8.1.2 The battery should store in the product specification book stipulation temperature range, the best
storage temp. is 0 to 25. The best humidity is 60±25%.
8.2 Transportation:
8.2.1 Do not mix the battery products with other cargos.
8.2.2 Do not immerse the battery products in water or allow it to get wet.
8.2.3 Do not over 7 layers staking and upside-down.
8.2.4 The highest temperature in transportation is lower than 65.
9. Use Attentions:
To ensure proper use of the battery please read the manual carefully before using it.
9.1 Handling:
9.1.1 Do not expose to, dispose of the battery in fire.
9.1.2 Do not put the battery in a charger or equipment with wrong terminals connected.
9.1.3 Avoid shorting the battery
9.1.4 Avoid excessive physical shock or vibration.
9.1.5 Do not disassemble or deform the battery.
9.1.6 Do not immerse in water.
9.1.7 Do not use the battery mixed with other different make, type, or model batteries.
9.1.8 Keep out of the reach of children.
9.2 Charge:
9.2.1 Battery must be charged in appropriate charger only.
9.2.2 Never use a modified or damaged charger.
9.2.3 Do not leave battery in charger over 24 hours.
9.2.4 Charging current: Can not surpass the biggest charging current which in this specification book
stipulated.
9.2.5 Charging voltage: Does not have to surpass the highest amount which in this specification book
stipulated to decide the voltage.
9.2.6 Charge temperature: The battery must carry on the charge in the ambient temperature scope which
this specification book stipulated.
9.2.7 Uses the constant electric current and the constant voltage way charge, the prohibition reverse
charges. If the battery positive and cathode meet instead, it can damage the battery.
9.2.8 The battery must be stored after charged, and should be charged and discharged once every 3
months.
9.3 Discharge:
9.3.1 The discharging current does not have to surpass this specification book stipulation the biggest
discharging current, the oversized electric current electric discharge can cause the battery capacity
play to reduce and to cause the battery heat
9.3.2 Electric discharge temperature: The battery discharge must carry on in the ambient temperature
scope which this specification book stipulated.
9.3.3 Over-discharges: After the short time excessively discharges charges immediately cannot affect the
use, but the long time excessively discharges can cause the battery the performance, battery function
losing. The battery long-term has not used, has the possibility to be able to be at because of its
深圳市海盛电池有限公司
Shenzhen Hypercell Company Limited
Page 1 2 o f 1 2
automatic flashover characteristic certain excessively discharges the condition, for prevented
excessively discharges the occurrence, the battery should maintain the certain electric quantity.
9.4 Disposal:
Regulations vary for different countries. Dispose of in accordance with local regulations.
10. Period of Warranty
There is a twelve-month warranty for our export batteries from the date of shipment. If the problem
happened during the warranty period, we are responsible to replace the defective ones according to the
accurate analysis results. However, we won't take any responsibility if the problem is caused by the
battery-related applications and related products.
11. Others
Because batteries utilize a chemical reaction, battery performance will deteriorate over time even if stored
for a long period of time without being used. In addition, if the various usage conditions such as charge,
discharge, ambient temperature, etc. are not maintained within the specified ranges the life expectancy of
the battery may be shortened or the device in which the battery is used may be damaged by electrolyte
leakage. If the batteries cannot maintain a charge for long periods of time, even when they are charged
correctly, this may indicate it is time to change the battery.
12. Note:
Any other items which are not covered in this specification shall be agreed by both parties.

MIKROE-2759

Mfr. #:
Manufacturer:
Description:
3.7V 190MAH LI-POLYMER BATTERY
Lifecycle:
New from this manufacturer.
Delivery:
DHL FedEx Ups TNT EMS
Payment:
T/T Paypal Visa MoneyGram Western Union

Products related to this Datasheet