Z-230TJ

Z-BLOCKER
®
Z-230TJ
In-Line DSL Filter
Description
The Z-230TJ is a small in-line filter designed to
expedite the service delivery and improve the
performance of digital subscriber line (DSL)
and home phoneline network (HPN) services.
This model filters all telephone sets, facsimile
machines, answering machines, etc individually
or in groups on line 1 only. It also provides a
second jack that is unfiltered for connecting
DSL and/or HPN. Our in-line DSL filter design
electronically isolates the high-speed DSL and
HPN data streams from the voice band plain old
telephone service (POTS) This design
effectively blocks the DSL, HPN and other
radio frequencies up to 10 Megahertz.
Features
Isolate telephone equipment impedances
from the xDSL and HPN systems
Attenuate xDSL & HPN signals to phone
equipment to prevent conversion to voice
band signals
Attenuate HPN signals to unbalanced phone
equipment to prevent radiation into
electronic equipment
Attenuate radio signals picked up by
unbalanced telephone acting as an antenna
from effecting DSL or HPN receivers
Minimize voice band interference ---
transmission, signaling and supervision
Compatible with all major xDSL standards
including ADSL Full Rate (ITU-T G.992.1),
ADSL G.Lite (ITU-T G.992.2), ADSL2
(ITU-T G.992.3 and .4), ADSL2+ (ITU-T
G.992.5 in analog mode), ADSL2++, VDSL
(ITU-T G.993.1), VDSL2; also V.90 and
Metallic Loop Testing compatible
FCC CFR 47 Part 68; UL 1950, and CSA
22.2 #950-5 compliant and listed
Applications
The Z-230TJ filters are used with other
Z-BLOCKER
®
filters distributed throughout the
subscribers’ premises to isolate all voice band
equipment devices such as corded/cordless
telephones, answering machines, fax machines,
56Kb/s and lower rate modems, automatic
dialers, recorder connectors and satellite
television set-top boxes.
The Z-230TJ in-line DSL filter is one of many
filters manufactured by Excelsus for subscriber
installed digital services within homes, offices,
and hotels. Excelsus is the number one selling
brand of DSL filters worldwide.
Z-230TJ In-Line DSL Filter
Series 230 and 250 Z-BLOCKER
Filter Specifications
Line side differential input blocking impedance
At 20 kHz >2k
At 30 kHz >3k
From 5 MHz to 10 MHz >2k
From 10 MHz to 400 MHz N/A
1 kHz insertion loss between 600 Ohm resistive
Single filter <0.4
With 5 filters <0.6
1 kHz/2.8 kHz slope between 600 Ohm resistive
Single filter <0.1
With 5 filters <1.1
DC resistance in Ohms
Tip to Tip, and Ring to Ring <12
Tip to Ring >10M
Longitudinal Balance per IEEE method
From 200 - 1 kHz >58dB
From 1 kHz - 3 kHz >53dB
Common mode rejection, 40 kHz and 1.1 MHz >45dB
Low pass roll off (slope) between 600 Ohm and ADSL Transmission Unit - Remote >26dB
Inter-Modulation Distortion First and Second order products >60dB
Envelope Delay 300 Hz - 2800 Hz <100µs
600 Ohm Return Loss into phone side with 600 Ohm line termination with ATU-R
Single filter SRL Low >30dB
ERL >14dB
SRL High >17dB
+2 bridged filters SRL Low >36dB
ERL >23dB
SRL High >13dB
+4 bridged filters SRL Low >26dB
ERL >15dB
SRL High >8dB
Complex* Return Loss with ATU-R
Single filter SRL Low >27dB
Single filter ERL >14dB
Single filter SRL High >6dB
+ 2 bridged filters SRL Low >19dB
ERL >14dB
SRL High >3dB
+ 4 bridged filters SRL Low >15dB
ERL >7dB
SRL High >2dB
* 1330 Ohms in parallel with (100nfd in series with 348 Ohms)
DC Loop Current – Meets specifications between 20 and 100 milliamps DC
Isolates dial pulses and on-hook/off-hook transitions from the digital subscriber line
Dimensions: Length 1.5in (39mm), Width 1.1in (27mm), Height 0.84in (21mm),
Cord Length = 4.0in (102mm)
12220 World Trade Drive, San Diego, CA 92128 USA
Toll-free 800-457-0967 Direct 760-476-1511 Fax 858-385-8003
www.excelsus-tech.com sales@excelsus-tech.com
© 2005 Pulse Engineering, Inc. Specifications subject to change without notice. Rev. H

Z-230TJ

Mfr. #:
Manufacturer:
Pulse Electronics
Description:
FILTER DSL/SINGLE IN-LINE PHONE
Lifecycle:
New from this manufacturer.
Delivery:
DHL FedEx Ups TNT EMS
Payment:
T/T Paypal Visa MoneyGram Western Union

Products related to this Datasheet