Warranty/Remedy
Honeywell warrants goods of its manufacture as being free of
defective materials and faulty workmanship during the appli-
cable warranty period. Honeywell’s standard product warranty
applies unless agreed to otherwise by Honeywell in writing;
please refer to your order acknowledgement or consult your
local sales office for specific warranty details. If warranted
goods are returned to Honeywell during the period of coverage,
Honeywell will repair or replace, at its option, without charge
those items that Honeywell, in its sole discretion, finds defec-
tive. The foregoing is buyer’s sole remedy and is in lieu of all
other warranties, expressed or implied, including those of
merchantability and fitness for a particular purpose. In no
event shall Honeywell be liable for consequential, special,
or indirect damages.
While Honeywell may provide application assistance personally,
through our literature and the Honeywell web site, it is buyer’s
sole responsibility to determine the suitability of the product in
the application.
Specifications may change without notice. The information we
supply is believed to be accurate and reliable as of this writing.
However, Honeywell assumes no responsibility for its use.
0086385EN IL50 GLO
October 2016
© 2016 Honeywell International Inc. All rights reserved.
Teflon
®
is a registered trademark of E.I. duPont de Nemours
m WARNING
PERSONAL INJURY
DO NOT USE these products as safety or emergency stop
devices or in any other application where failure of the
product could result in personal injury.
Failure to comply with these instructions could result in
death or serious injury.
m WARNING
MISUSE OF DOCUMENTATION
• The information presented in this product sheet is for
reference only. Do not use this document as a product
installation guide.
• Complete installation, operation, and maintenance
information is provided in the instructions supplied with
each product.
Failure to comply with these instructions could result in
death or serious injury.
Find out more
Honeywell serves its customers
through a worldwide network of
sales offices, representatives and
distributors. For application as-
sistance, current specifications,
pricing or name of the nearest
Authorized Distributor, contact
your local sales office.
To learn more about Honeywell’s
test and measurement products,
call +18152356847 or
18005376945,
visit sensing.honeywell.com, or
e-mail inquiries to
info.tm@honeywell.com
Honeywell Safety and Productivity Solutions
9680 Old Bailes Road
Fort Mill, SC 29707
honeywell.com
Figure 4. Typical System Diagram
NOTES
1. Allowable maximum loads – maximum load to be applied without
damage.
2
2. Without damage - loading to this level will not cause excessive
zero shift or performance degradation. The user must consider
fatigue life for long term use and structural integrity. All structur-
ally critical applications (overhead loading, etc.) should always be
designed with safety redundant load paths.
3. TEDS IEEE 1454.4 module installed at end of cable.
4. Maximum operating temperature for options 53S and 53T
is 85 °C [185 °F]
Model 53
Customer supplied
Chart recorder
Alarm panel
Data acquisition
Computer
PLC
Display units
SC500
SC2000
SC2001
SC3004
GM
NK
HH
In-line amplifiers (used with unamplified units only)
Amplifier Output
Universal in-line amplifiers
UV ±5 Vdc
UV-10 ±10 Vdc
UBP 0 ±5 Vdc
U3W 4 mA to 20 mA (3-wire)
DIN rail mount in-line amplifiers
DV-05 0 ±5 Vdc (3-wire)
DA-05 4 mA to 20 mA (3-wire)
DV-10 0 ±10 Vdc (3-wire)