AN8011S
2
SDH00002BEB
■ Pin Descriptions
Pin No. Symbol Description
1 CT Pin for connecting the oscillation frequency setting capacitor for triangular oscillation
circuit. Frequency of triangular oscillation is set by connecting a capacitor between this
terminal and GND.
2 RT Resistor connection pin for setting the oscillation frequency of triangular oscillation
circuit. Frequency of triangular oscillation is set by connecting resistance between the
pin and GND
3 On/Off "On/Off" pin for turning on/off IC. "Low" stops IC (output off) and "High" operates IC.
4IN−2 Inverted input pin for channel 2 error amplifier
5 F/B 2 Output pin for channel 2 error amplifier. Gain setting or phase compensation is perfor-
med by connecting resistor or capacitor between the pin and IN−2. It is also connected
to PWM short-circuit protection.
6 DTC 2 Pin for setting dead-time period of channel 2. The dead-time of channel 2 is set by conn-
ecting external resistor. Soft start function can be also given by connecting capacitor in
parallel with the external resistor. In addition, only channel 2 output can be turned off by
decreasing the pin voltage to below 0.12 V. (short-circuit protection function stop circuit)
7 Out 2 Channel 2 open-collector type output pin. I
O
= 100 mA maximum
8 GND Grounding pin of signal system.
9V
CC
Power supply voltage application pin. It detects start voltage and stop voltages
10 Out 1 Channel 1 open-collector type output pin. I
O
= 100 mA maximum
11 DTC 1 Pin for setting dead-time period of channel 1. The dead-time period of channel 1 is set by
connecting external resistor. Soft start function can be also given by connecting capacitor in
parallel with the external resistor. In addition, only channel 1 output can be turned off by
decreasing the pin voltage to below 0.12 V. (short-circuit protection function stop circuit)
12 F/B 1 Output pin for channel 1 error amplifier. Gain setting or phase compensation is perfor-
med by connecting resistor or capacitor between the pin and IN−1. It is also connected
to PWM short-circuit protection.
13 IN−1 Inverted input pin for channel 1 error amplifier.
14 IN+ Pin for noninverted input of channel 1 error amplifier.
15 Latch Pin for connecting the time constant setting capacitor for timer latch type short-circuit
protection circuit. The time constant for short-circuit protection is set by connecting a capa-
citor between this terminal and GND.
16 V
REF
Internal reference voltage output pin (2.5 V (allowance: ±3%)). If a load of 20 mA typical
or more is applied, the overcurrent protection operates to reduce V
REF
and switching
operation stops.