Bel Fuse Inc. 206 Van Vorst Street, Jersey City, NJ 07302 • Tel 201-432-0463 • Fax 201-432-9542 • www.belfuse.com
NON-ISOLATED DC/DC CONVERTERS
8.3 Vdc - 14 Vdc Input 0.75 Vdc - 5.0 Vdc/10 A Output
Input Specifications
Parameter Min Typ Max Notes
Input Voltage
Vo, set
≤ 3.63 V
Vo, set
> 3.63 V
8.3 V
8.3 V
12 V
12 V
14 V
13.2 V
Input Current (full load) - - 6.5 A
An input line fuse must always be
used.
Input Current (no load) - 50 mA -
Remote Off Input Current - 2 mA -
Input Reflected Ripple Current
(pk-pk)
- - 400 mA
Input Reflected Ripple Current
(rms)
- - 150 mA
Tested with one 1000 uF/25 V AL
input capacitor with ESR=0.03 ohm
max and 4 × 47 uF/16 V tan
capacitors with ESR=0.013 ohm max
at 100 kHz, & simulated source
impedance of 1000 nH, 5 Hz to
20 MHz.
I
2
t Inrush Current Transient - 0.04 A
2
s 0.08 A
2
s
Turn-on Voltage Threshold - 8.2 V
Turn-off Voltage Threshold - 7.9 V
Note: All specifications are typical at 25 °C unless otherwise stated.
Output Specifications
Parameter Min Typ Max Notes
Output Voltage Set Point -2% Vo,set - 2% Vo,set Vin=12 V, full load
Load Regulation - 0.1% Vo,set -
Line Regulation - 0.1% Vo,set -
Regulation Over Temperature
(-40 °C to +85 °C)
- 0.3% Vo,set - Tref=Tamin to Tamax
Output Current 0 A - 10 A
Current Limit Threshold - 200% Io -
Short Circuit Surge Transient
- 1 A
2
s 3 A
2
s
Ripple and Noise (pk-pk) - 50 mV 100 mV
Ripple and Noise (rms) - 20 mV 40 mV
Tested with 0-20 MHz, with 10 uF
tantalum capacitor & 1 uF
ceramic ca
acitor
Turn on Time - 6 mS 10 mS
Overshoot at Turn on - - 1% Vo,set
Output Capacitance - - 5000 uF
Transient Response
50% ~ 100% Max Load - 100 mV -
Settling Time - 50 uS -
100% ~ 50% Max Load - 100 mV -
Settling Time
V
O = 0.75 V -
5 V
- 50 uS
-
di/dt=2.5 A/uS; Vin=12 V;
and with 2 × 150 uF polymer
capacitors at the output
Note: All specifications are typical at nominal input, full load at 25 °C unless otherwise stated.