Document Number: 38-06001 Rev. *K Page 6 of 22
Maximum Ratings
Exceeding maximum ratings may impair the useful life of the
device. These user guidelines are not tested.
[1]
Storage Temperature ............................... –65 °C to +150 °C
Ambient Temperature
with Power Applied .................................. –55 °C to +125 °C
Supply Voltage to Ground Potential .............–0.5 V to +7.0 V
DC Voltage Applied to Outputs
in High Z State .............................................–0.5 V to +7.0 V
DC Input Voltage .........................................–0.5 V to +7.0 V
Power Dissipation ........................................................ 1.0 W
Output Current, into Outputs (LOW) ........................... 20 mA
Static Discharge Voltage
(per MIL–STD–883, Method 3015) ......................... > 2000 V
Latch Up Current ...................................................> 200 mA
Operating Range
Range Ambient Temperature
[2]
V
CC
Commercial 0 °C to +70 °C 5 V ± 10%
Industrial –40 °C to +85 °C 5 V ± 10%
Electrical Characteristics
Over the Operating Range
Parameter Description Test Conditions
All Speed Grades
Unit
Min Max
V
OH
Output HIGH Voltage V
CC
= Min, I
OH
= –2.0 mA 2.4 – V
V
OL
Output LOW Voltage V
CC
= Min, I
OL
= 8.0 mA – 0.4 V
V
IH
Input HIGH Voltage Commercial 2.0 V
CC
V
Industrial 2.2 V
CC
V
IL
Input LOW Voltage
[3]
0.8 V
I
IX
Input Leakage Current GND < V
I
< V
CC
–10 +10 μA
I
OZ
Output Leakage Current R > V
IH
, GND < V
O
< V
CC
–10 +10 μA
I
OS
Output Short Circuit Current
[4]
V
CC
= Max, V
OUT
= GND – –90 mA
Electrical Characteristics
Over the Operating Range
Parameter Description Test Conditions
-15 -20
Unit
Min Max Min Max
I
CC
Operating Current V
CC
= Max, I
OUT
= 0 mA,
f = f
MAX
Commercial – 65 – 55 mA
Industrial – 100 – 90
I
CC1
Operating Current V
CC
= Max, I
OUT
= 0 mA,
f = 20 MHz
Commercial – 35 – 35 mA
I
SB1
Standby Current All Inputs = V
IH
Min Commercial – 10 – 10 mA
Industrial – 15 – 15
I
SB2
Power Down Current All Inputs > V
CC
– 0.2 V Commercial – 5 – 5 mA
Industrial – 8 – 8
Notes
1. Single Power Supply: The voltage on any input or I/O pin cannot exceed the power pin during power up.
2. T
A
is the “instant on” case temperature.
3. V
IL(Min)
= –2.0 V for pulse durations of less than 20 ns.
4. For test purposes, not more than one output at a time should be shorted. Short circuit test duration should not exceed 30 seconds.
