17
Register and Bit De nitions (continued)
Main Backlight Current Control Register (01h)
This register is used to set the currents for the backlight
current sinks assigned to the Main Backlight Group. This
group can also be used to control red LEDs for limited RGB
control. These current sinks need to be enabled in the
Backlight Enable Control register to be active.
Bit D5
This bit is unused and is always a zero, so the maximum
pulse count for this register is 31.
MBL4 — MBL0 [D4:D0]
These bits are used to set the current for the main back-
light current sinks. All enabled main backlight current
sinks will sink the same current, as shown in Table 4.
Table 4 — Main Backlight Current Settings
MBL4 MBL3 MBL2 MBL1 MBL0 Backlight Current (mA)
00000 0
0 0 0 0 1 See note 1
0 0 0 1 0 See note 1
0 0 0 1 1 See note 1
00100 0.5
00101 1.0
00110 1.5
00111 2.0
01000 2.5
01001 3.0
01010 3.5
01011 4.0
01100 4.5
01101 5.0
01110 6.0
01111 7.0
10000 8.0
10001 9.0
10010 10
10011 11
10100 12
10101 13
10110 14
10111 15
11000 16
11001 17
11010 18
11011 19
11100 20
11101 21
11110 23
11111 25
(1) Reserved for future use
SC654