http://www.tracopower.com Page 2 of 3
All specifications valid at nominal input voltage, full load and +25°C after warm-up time unless otherwise stated.
DC/DC Converters
TMR 2E Series 2 Watt
Input Specifications
Input current at no load (nominal input voltage) 5.0 Vin models: 40 mA typ.
12 Vin models: 20 mA typ.
24 Vin models: 10 mA typ.
48 Vin models: 8 mA typ.
Input current at full load (nominal input voltage) 5.0 Vin models: 520 mA typ.
12 Vin models: 200 mA typ.
24 Vin models: 100 mA typ.
48 Vin models: 50 mA typ.
Surge voltage (1000 msec. max.) 5.0 Vin models: 15 V max.
12 Vin models: 25 V max.
24 Vin models: 50 V max.
48 Vin models: 100 V max.
Input filter Internal capacitor
Input voltage variation (dv/dt) 5 V/ms, max.
(complies with ETS300 132 part 4.4)
Reflected input ripple current 5.0 Vin models: 400 mA typ.
12 Vin models: 300 mA typ.
24 Vin models: 200 mA typ.
48 Vin models: 500 mA typ.
Conducted noise (input) EN 55032 level A, FCC part 15, level A
with external capacitor
Output Specifications
Voltage set accuracy ±2 % max.
Regulation – Input variation Vin min. to Vin max. 0.5 % max.
– Load variation 25 – 100% 0.75 % max.
Minimum load 25 % of rated max. load (operation at lower
load condition is safe but a higher output ripple
will be experienced)
Temperature coefficient 0.02 %/K
Ripple and noise (20 MHz bandwidth) 50 mVpk-pk max.
Transient response setting time (25 % load step change) 100 µs typ.
Current limitation >120 % of Iout max. constant current
Short circuit protection continuous, automatic recovery
Capacitive load 3.3 VDC models: 2‘200 µF max.
5 VDC models: 1‘000 µF max.
12 VDC models: 170 µF max.
General Specifications
Temperature ranges – Operating –40°C to +85°C (with derating)
– Case temperature +90°C max.
– Storage –55°C to +105°C
Load derating 1.5 %/K above +65°C
Humidity (non condensing) 95 % rel. H max.
Reliability, calculated MTBF (MIL-HDBK-217F, at +25°C, ground benign) >1 Mio h
Isolation voltage – Input/Output 1’000 VDC (60 s)
1‘200 VDC (1 s)
Isolation capacitance – Input/Output 120 pF max.
Isolation resistance – Input/Output (500 VDC) >1 GOhm