408-4228
4 of 6
Rev C
3. Position the contact so that the mating end of the
contact is on the locator side of the tool, and so that
the open "U" of the wire and insulation barrels must
face the top of the tool. Place the contact up into the
nest so that the movable locator drops into the slot
in the contact. Refer to Figure 3. Butt the front end
of the wire barrel against the movable locator.
Make sure that both sides of the insulation barrel
are started evenly into the crimping section. Do not
attempt to crimp an imprope
rly positioned contact.
4. Hold the contact in position and squeeze the tool
h
andles together until ratchet engages sufficiently to
hold the contact in position. Do NOT deform
insulation barrel or wire barrel.
5. Insert stripped
wire into contact insulation and
wire barrels until it is butted against the wire stop, as
shown in Figure 3.
6. Holding the wire in place, squeeze tool handles
tog
ether until ratchet releases. Allow tool handles to
open and remove crimped contact.
The crimped contact may stick in the crimping area,
but the contact can be easily removed by pushing
downward on the top of the locator (se
e Figure 3).
7. Check the contact's crimp height as described in
Se
ction 6, Crimp Height Inspection. If necessary,
adjust the crimp height as described in Section 7,
RATCHET ADJUSTMENT.
6. CRIMP HEIGHT INSPECTION
Crimp height inspection is performed through the use
of a micrometer with a modified anvil, commonly
referred to as a crimp-height comparator. Tyco
Electronics does not manufacture or market crimp-
height comparators. Detailed information on obtaining
and using crimp-height comparators can be found in
Instruction Sheet 408-7424.
Proceed as follows:
1. Refer to Figure 1 and select a wire (maximum
size)
for each crimp section listed.
2. Refer to Section
5, CRIMPING PROCEDURE,
and crimp the contact(s) accordingly.
3. Using a crimp height comparator, measure the
wir
e barrel crimp height as shown in Figure 4. If the
crimp height conforms to that shown in the table,
the tool is considered dimensionally correct. If not,
the tool must be adjusted. Refer to Section 7,
RATCHET ADJUSTMENT.
7. RATCHET ADJUSTMENT (Figure 5)
1. Remove the lockscrew from the ratchet
adjustment wheel.
WIRE SIZE
AWG (Max)
CRIMP SECTION
(WIRE SIZE
MARKINGS)
CRIMP HEIGHT
DIM.(A) AND
TOLERANCE
(±) .05 [.002]
20 24-20 L 1.02 [.040]
18 18 1.30 [.051]
20 24-20 S 1.02 [.040]
Figure 4
2. With a screwdriver, adjust the ratchet wheel from
the locator side of the tool.
3. Observe the ratchet adjustment wheel. If a tighter
crim
p is required, rotate the adjustment wheel
COUNTERCLOCKWISE to a higher-numbered
setting. If a looser crimp is required, rotate the
adjustment wheel CLOCKWISE to a lower-
numbered setting.
4. Replace the lockscrew.
5. Make a sample crimp and measure the crimp
he
ight. If the dimension is acceptable, replace and
secure the lockscrew. If the dimension is
unacceptable, continue to adjust the ratchet, and
again measure a sample crimp.
Lockscrew
(Typ)
Ratchet
Adjustment
Wheel
Screwdriver
Figure 5
