PI3CH480 www.diodes.com December 2017
Document Number DS40329 Rev 1-2 5 ©Diodes Incorporated
PI3CH480
Over 2.5V Operating Range
Symbol Description Test Conditions
(1)
Min Typ Max Unit
t
PLH,
t
PHL
Propagation Delay
(2, 3)
Y to In, In to Y See test Diagram - - 0.3
ns
t
PZH,
t
PZL
Enable Time S or EN to Y or In
See test Diagram 1.5 - 15.0
t
PHZ,
t
PLZ
Disable Time S or EN to Y or In
See test Diagram 1.5 - 12.0
Note:
1. See test circuit and waveforms.
2. This parameter is guaranteed but not tested on Propagation Delays.
3. The switch contributes no propagation delay other than the RC delay of the On-Resistance of the switch and the load capacitance. The
time constant for the switch alone is of the order of 0.30ns for 10pF load. Since this time constant is much smaller than the rise/fall
times of typical driving signals, it adds very little propagation delay to the system. Propagation delay of the switch when used in a
system is determined by the driving circuit on the driving side of the switch and its interaction with the load on the driven side.
Over 1.8V Operating Range
Symbol Description Test Conditions
(1)
Min Typ Max Unit
t
PLH,
t
PHL
Propagation Delay
(2, 3)
Y to In, In to Y See test Diagram - - 0.3
ns
t
PZH,
t
PZL
Enable Time S or EN to Y or In
See test Diagram 1.5 - 25.0
t
PHZ,
t
PLZ
Disable Time S or EN to Y or In
See test Diagram 1.5 - 12.0
Note:
1. See test circuit and waveforms.
2. This parameter is guaranteed but not tested on Propagation Delays.
3. The switch contributes no propagation delay other than the RC delay of the On-Resistance of the switch and the load capacitance. The
time constant for the switch alone is of the order of 0.30ns for 10pF load. Since this time constant is much smaller than the rise/fall
times of typical driving signals, it adds very little propagation delay to the system. Propagation delay of the switch when used in a
system is determined by the driving circuit on the driving side of the switch and its interaction with the load on the driven side.
Test Circuit for Electrical Characteristics
Notes:
1. C
L
= Load capacitance: includes jig and probe capacitance.
2.
R
T
= Termination resistance: should be equal to Z
OUT
of the Pulse Generator
3. All input impulses are supplied by generators having the following characteristics: PRR ≤ 10 MHz, Z
O
= 50-ohm, t
R
≤ 2.5ns, t
F
≤ 2.5ns.
4. The outputs are measured one at a time with one transition per measurement.
