OPERATING
TEMPERATURE RANGE
STORAGE
TEMPERATURE RANGE
VISUALLY AND BY MEASURING INSTRUMENT.
ELECTRICAL CHARACTERISTICS
10 mA MAX (DC OR 1000 Hz).
NO FLASHOVER OR BREAKDOWN.
MECHANICAL CHARACTERISTICS
INSERTION AND
WITHDRAWAL FORCES
MEASURED BY APPLICABLE CONNECTOR.
INSERTION FORCE 19.6 N MAX.
WITHDRAWAL FORCE 4 TO 19.6 N.
5000 TIMES INSERTIONS AND EXTRACTIONS.
1) CONTACT RESISTANCE : 50 m MAX.
2) NO DAMAGE, CRACK AND LOOSENESS
OF PARTS.
FREQUENCY 10 TO 55 Hz
SINGLE AMPLITUDE 0.75 mm,
ACCELERATION － m/s
2
,
AT 2 hours FOR 3 DIRECTIONS.
1)
NO ELECTRICAL DISCONTINUITY OF
1s.
2)
CONTACT RESISTANCE : 50 m MAX.
3)
NO DAMAGE, CRACK AND LOOSENESS
OF PARTS.
ACCELERATION 490 m/s
2
,
DURATION OF PULSE 11 ms
AT 3 TIMES FOR 6 DIRECTIONS.
ENVIRONMENTAL CHARACTERISTICS
RAPID CHANGE OF
TEMPERATURE
TEMPERATURE –55 → -55 TO 35 → +85 → 5 TO 35 C
TIME 30 → 5 → 30 → 5 min.
UNDER 5 CYCLES.
1) CONTACT RESISTANCE : 50 m MAX.
2) INSULATION RESISTANCE: 1000 M MIN.
3) NO DAMAGE, CRACK AND LOOSENESS
OF PARTS.
EXPOSED AT 40 C, 90 TO 95 RH, FOR 96 hours.
1) CONTACT RESISTANCE : 50 m MAX.
2) INSULATION RESISTANCE: 10 M MIN.
(AFTER DRY.)
3) NO DAMAGE, CRACK AND LOOSENESS
OF PARTS.
EXPOSED IN 5 % SALT WATER SPRAY FOR 48 hours.
1) CONTACT RESISTANCE : 50 m MAX.
2) NO SPECTACULAR CORRODE.
SOLDERING CONDITION
(REFLOW)
REFLOW TO THE REFLOW TEMPERATURE PROFILE
IN THE FIGURE-1 FOR 2 TIMES.
NO DAMAGE, CRACK AND LOOSENESS
OF PARTS.
Fig-1 Resistance to Soldering Heat Profile Fig-2 The Recommended Reflow Temperature Profile
(Connector Surface Temparature) (Connector Lead Temparature)
REMARK
Unless otherwise specified, refer to IEC 60512.
Note QT:Qualification Test AT:Assurance Test X:Applicable Test
HIROSE ELECTRIC CO., LTD.
FORM HD0011-2-1
Oct.1.2018 Copyright 2018 HIROSE ELECTRIC CO., LTD. All Rights Reserved.
In case that the application demands a high level of reliability, such as automotive,
please contact a company representative for further information.
Powered by TCPDF (www.tcpdf.org)
