LTC1998
6
1998fb
PIN FUNCTIONS
BATT (Pin 1): Battery Voltage to be monitored. Supply
current is also drawn from this pin. Board layout should
connect this pin to the battery(+) terminal, through a trace
that does not conduct load current.
GND (Pin 2): Ground should be connected to the battery
(–) terminal through a trace that does not conduct load
return current.
V
TH.A
(Pin 3): Threshold Adjust Pin. Adjusts the low battery
threshold voltage, V
BATT.Th
= 2.5V + (V
TH.A
/2). V
TH.A
can be
supplied by a voltage source or a resistor divider.
V
H.A
(Pin 4): Hysteresis Adjust. Hysteresis threshold
voltage V
TH2
= 2.5V + (V
H.A
/2). V
H.A
can be supplied by
a voltage source or resistor divider. V
H.A
must always be
programmed to a higher potential than V
TH.A
. Hysteresis
voltage, V
HYST
= V
TH2
– V
BATT.Th
.
V
LOGIC
(Pin 5): Positive Supply Voltage for Output Driver.
This voltage can be driven from an external logic supply
or tied to BATT.
BATTLO (Pin 6): Output of Comparator. Low for BATT
< V
BATT.Th
(low battery threshold voltage). Output state
guaranteed for V
BATT
≥ 1.5V.