SiP32461, SiP32462
www.vishay.com
Vishay Siliconix
S12-3088-Rev. B, 24-Dec-12
2
Document Number: 67754
For technical questions, contact: powerictechsupport@vishay.com
THIS DOCUMENT IS SUBJECT TO CHANGE WITHOUT NOTICE. THE PRODUCTS DESCRIBED HEREIN AND THIS DOCUMENT
ARE SUBJECT TO SPECIFIC DISCLAIMERS, SET FORTH AT www.vishay.com/doc?91000
Note
(1)
Negative current injection up to 300 mA
Stresses beyond those listed under “Absolute Maximum Ratings” may cause permanent damage to the device. These are stress ratings only, and functional operation
of the device at these or any other conditions beyond those indicated in the operational sections of the specifications is not implied. Exposure to absolute maximum
rating conditions for extended periods may affect device reliability.
ABSOLUTE MAXIMUM RATINGS
PARAMETER CONDITIONS LIMIT UNIT
Supply Input Voltage V
IN
Reference to GND - 0.3 to 6.5
V
Output Voltage V
OUT
Reference to GND - 0.3 to 6.5
Output Voltage OUT Pulse at 1 ms reference to GND
(1)
- 1.6
Enable Input Voltage EN Reference to GND - 0.3 to 6.5
Maximum Continuous Switch Current 1.2
A
Maximum Pulse Switch Current Pulse at 1 ms, 10 % duty cycle 2
ESD Rating (HBM) 4000 V
Thermal Resistance 280 °C/W
TEMPERATURE
Operating Temperature - 40 to 85
°COperating Junction Temperature 125
Storage Temperature - 65 to 150
RECOMMENDED OPERATING RANGE
ELECTRICAL PARAMETER MINIMUM TYPICAL MAXIMUM UNIT
Input Voltage (V
IN
) 1.2 - 5.5 V
SPECIFICATIONS
PARAMETER SYMBOL
TEST CONDITION UNLESS SPECIFIED
V
IN
= 1.2 V TO 5.5 V, T
A
= - 40 °C to 85 °C
(Typical values are at 25 °C)
LIMITS
UNIT
MIN. TYP. MAX.
POWER SUPPLY
Quiescent Current I
Q
V
IN
= 3.3 V, V
OUT
= 0 mA - 4.5 7
μA
Shutdown Current I
SD
V
OUT
= GND - 0.01 2
Off Switch Current I
DS(off)
EN = GND, out = GND - 0.01 2
Reverse Blocking Current I
(in)RB
Out = 5 V, IN = 1.2 V, EN = 0 V, (Measured at in pin) - 0.01 1
Out = 5 V, IN = 0 V, EN = 0 V, (Measured at in pin) - 0.01 1
SWITCH RESISTANCE
On Resistance R
DS(on)
I
OUT
= 500 mA, V
IN
= 1.2 V, T
A
= 25 °C - 95 150
m
I
OUT
= 500 mA, V
IN
= 1.5 V, T
A
= 25 °C - 80 120
I
OUT
= 500 mA, V
IN
= 1.8 V, T
A
= 25 °C - 70 100
I
OUT
= 500 mA, V
IN
= 3 V, T
A
= 25 °C - 54 65
I
OUT
= 500 mA, V
IN
= 5 V, T
A
= 25 °C - 52 65
Discharge Switch On
Resistance
R
PD
When V
IN
= 3 V at 25 °C - 80 -
When V
IN
= 1.8 V at 25 °C - < 200 -
EN Pin Pull Down Resistor R
EN
EN = 1.2 V 1 2.6 5 M
On Resistance Temperature
Coefficient
TC
RDS
- 2800 ppm/°C
ON/OFF LOGIC
EN Input Low Voltage V
IL
V
IN
= 1.5 V 0.4 - -
V
EN Input High Voltage V
IH
V
IN
= 5.5 V - - 1
