2004 Jan 13 13
Philips Semiconductors Product specification
LIN transceiver TJA1020
Notes
1. All parameters are guaranteed over the virtual junction temperature by design, but only 100% tested at 125 °C
ambient temperature for dies on wafer level and, in addition to this, 100% tested at 25 °C ambient temperature for
cased products, unless otherwise specified.
2. For bare die, all parameters are only guaranteed if the backside of the bare die is connected to ground.
3. If V
BAT
is higher than 12 V, the battery current increases due to the internal LIN termination resistor. The minimum
value of this resistor is 20 kΩ. The maximum current increase is therefore:
4. ; see Fig.6.
5. ; see Fig.6.
TIMING DIAGRAMS
I
BAT increase()
V
BAT
12 V–
20 kΩ
--------------------------------
=
t
f(slope)(dom)
t
VLIN
40%=()t
VLIN
95%=()–
0.55
--------------------------------------------------------------------------------
=
t
r(slope)(rec)
t
VLIN
60%=()t
VLIN
5%=()–
0.55
-----------------------------------------------------------------------------
=
handbook, full pagewidth
MGW323
50% 50%TXD
RXD
V
LIN
0%
5%
50%
t
PropRxDom
t
PropRxRec
t
PropTxDom
t
PropTxRec
0.5 V
BAT
0.5 V
BAT
100%
95%
t
50%
Fig.5 Timing diagram for AC characteristics, bus loaded.