ATASHEET
LAMP
EALP05RDEWA1
10
Copyright © 2010, Everlight Americas Inc. All Rights Reserved. Release Date : Mar.18, 2013.. Issue No: 1
americas.com
6. Heat Management
Heat management of LEDs must be taken into consideration during the design stage of LED application. The
current should be de-rated appropriately by referring to the de-rating curve found in each product
specification.
The temperature surrounding the LED in the application should be controlled. Please refer to the data sheet
de-rating curve.
7. ESD (Electrostatic Discharge)
The products are sensitive to static electricity or surge voltage. ESD can damage a die and its reliability.
When handling the products, the following measures against electrostatic discharge are strongly
recommended:
Eliminating the charge
Grounded wrist strap, ESD footwear, clothes, and floors
Grounded workstation equipment and tools
ESD table/shelf mat made of conductive materials
Proper grounding is required for all devices, equipment, and machinery used in product assembly.
Surge protection should be considered when designing of commercial products.
If tools or equipment contain insulating materials such as glass or plastic,
the following measures against electrostatic discharge are strongly recommended:
Dissipating static charge with conductive materials
Preventing charge generation with moisture
Neutralizing the charge with ionizers.
8. Other
Above specification may be changed without notice. Everlight Americas will reserve authority on material
change for above specification.
When using this product, please observe the absolute maximum ratings and the instructions for using
outlined in these specification sheets. Everlight Americas assumes no responsibility for any damage
resulting from use of the product which does not comply with the absolute maximum ratings and the
instructions included in these specification sheets.
These specification sheets include materials protected under copyright of Everlight Americas corporation.
Please don’t reproduce or cause anyone to reproduce them without Everlight Americas’ consent.
