IMM01 Series
www.xppower.com
2
DC-DC Converter
Input
Output
Characteristic Minimum Typical Maximum Units Notes & Conditions
O
utput Voltage 3.3 30 VDC See Models and Ratings table
P
atient Leakage Current 2 µA
Initial Set Accuracy
±
2
%
3
.3 V & 5.0 V at full load
±1 12.0 V & 15.0 V at full load
M
inimum Load 0%No minimum load required
Line Regulation ±0.5 % From minimum to maximum input
L
oad Regulation 2.0 % From 10% to full load (2% from 0% to 10% load)
C
ross Regulation ±5 %
O
n dual output models, when one output is at 25% load
and other is varied from 10% load to full load
Ripple & Noise 1/2 % pk-pk
For 12 V & 15 V/ 3.3 V & 5 V models. 20 MHz bandwidth.
Measured using 0.1 µF ceramic capacitor
Short Circuit Protection Continuous fold-back mode, with auto recovery
Maximum Capacitive Load See Models and Ratings table
Temperature Coefficient 0.03 %/ ˚C
Overload Protection 190 250 310 % Of nominal output current at nominal input voltage
Remote On/Off
Output is on if remote on/off (pin 3) is open
Output turns off if 2-4 mA is applied to remote on/off (pin 3)
C
haracteristic
M
inimum
T
ypical
M
aximum
U
nits
N
otes & Conditions
I
nput Voltage Range
4
.5 9 VDC 5 V nominal
9 18 VDC 12 V nominal
Inrush Current 0.05 A
2
s
I
nput Reflected Ripple Current 30 mA pk-pk Through 12 µH inductor and 47 µF capacitor
Input Surge
1
6 VDC for 100 ms 5 V models
2
5 VDC for 100 ms 12 V models
General
Characteristic Minimum Typical Maximum Units Notes & Conditions
Efficiency 64 78 81 % Typical value is for IMM0112S12
Isolation: Input to Output 1500 VAC At 250 VAC working voltage, 1 MOPP
Switching Frequency 175 1000 kHz May enter burst mode frequency of 12-28 kHz at light load
Isolation Resistance 10
9
Ω
Isolation Capacitance 27
pF
Power Density 8.31 W/in
3
Mean Time Between Failure 1 MHrs MIL-HDBK-217F, +25 °C GB
Weight 0.008 (3.6) lb (g)
Environmental
Characteristic Minimum Typical Maximum Units Notes & Conditions
Operating Altitude 3048 M
Transport Altitude 10,000
Operating Temperature -20 +100 °C
Derate linearly from 100% load at +60 °C to 0% at
+100 °C
Storage Temperature -40 +125 °C
Case Temperature +105 °C
Humidity 95 %RH Non-condensing
Cooling Natural convection