MP2603 – SINGLE CELL 150mA LINEAR LI-ION BATTERY CHARGER
MP2603 Rev. 1.01 www.MonolithicPower.com 4
1/31/2013 MPS Proprietary Information. Patent Protected. Unauthorized Photocopy and Duplication Prohibited.
© 2013 MPS. All Rights Reserved.
PIN FUNCTIONS
Pin # Name Description
1 IPGM
Charge Current Program Pin. Connect to a resistor to program the charge current. Do not
connect a capacitor to this pin.
2 GND Chip Ground Return. Connect to the system ground.
3 CHGZ
Open-Drain Charge Status Indication Pin. It can be connected through an LED and a 430Ω
resistor to BATT for visual indication or through a 1kΩ resistor to BATT for use with a
microcontroller.
4 IN
Input Supply Pin. Connect to a 5V (±5%) power supply. The maximum surge voltage must be
less than 25V. Decouple this pin with a minimum of 0.1µF ceramic capacitor.
5 BATT Charger Output. Connect to the battery. Placing a capacitor to GND on this pin is optional.
BLOCK DIAGRAM
BATTERY
CHARGE
CONTROL
2
IPGM
IN
BATT
CHGZ
GND
1
4
5
3
R
Figure 1—Functional Block Diagram