Inductance vs Current Characteristics
Notes from Tables
1. The temperature of the component (ambient plus temperature
rise) must be within the specified operating temperature range.
2. Inductance at Irated is a typical inductance value for the
component taken at rated current.
3. The rated current listed is the lower of the saturation current
@ 25°C or the heating current.
4. The saturation current, Isat, is the current at which the
component inductance drops by 20% (typical) at an ambient
temperature of 25°C. This current is determined by placing the
component in the specified ambient environment and applying a
short duration pulse current (to eliminate self-heating effects) to
the component.
5. The heating current, I
DC
, is the DC current required to raise the
component temperature by approximately 40°C. The heating
current is determined by mounting the component on a typical
PCB and applying current for 30 minutes. The temperature is
measured by placing the thermocouple on top of the unit under
test. Take note that the component’s performance varies
depending on the system condition. It is suggested that the
component be tested at the system level, to verify the
temperature rise of the component during system operation.
6. Core loss approximation is based on published core data:
Core Loss = K1 * (f)
1.035
* (K2ΔI)
2.263
Where: Core Loss = in Watts
f = switching frequency in kHz
K1 & K2 = core loss factors
ΔΔ
I = delta I across the component in Ampere
K2
ΔΔ
I = one half of the peak to peak flux density
across the component in Gauss
7. Unless otherwise specified, all testing is made at 100kHz, 0.1V
AC.
8.
Optional Tape & Reel packaging can be ordered by adding a "T"
suffix to the part number (i.e. PG0083.472 becomes
PG0083.472T). Pulse complies to industry standard tape
and reel specification EIA481.
