Quick Start
The MAX2750/MAX2751/MAX2752 EV kits are fully
assembled and factory tested. Follow the instructions in
the Connections and Setup section for proper device
evaluation.
Test Equipment Required
This section lists the recommended test equipment to
verify operation of the MAX2750/MAX2751/MAX2752. It
is intended as a guide only, and some substitutions are
possible.
• A two-channel power supply at +2.7V to +5.5V
• An ammeter (optional)
• An RF spectrum analyzer (HP 8561E, for example)
that covers the operating frequency range of the
MAX2750/MAX2751/MAX2752, as well as a few har-
monics
• A 50Ω SMA cable
Connections and Setup
This section provides a step-by-step guide to the func-
tions and operation of these EV kits.
1) Connect a DC supply set to +3V (through an amme-
ter, if desired) to the V
CC
and GND terminals on the
EV kit.
2) Apply +3V to the SHDN control input.
3) Turn on the DC supply. The supply current should
read about 10mA.
4) Connect the VCO output to a spectrum analyzer
with a 50Ω coaxial cable (minimize length).
5) Apply a variable DC voltage to the TUNE input
(+0.4V to +2.4V).
6) Check f
MIN
and f
MAX
on the spectrum analyzer by
varying the tuning voltage.
7) Check the output power level (-3dBm typ).
General Description
The MAX2750/MAX2751/MAX2752 evaluation kits
(EV kits) simplify evaluation of the MAX2750/MAX2751/
MAX2752 VCOs. These kits enable testing of the
devices’ RF performance and require no additional
support circuitry. The signal output uses an SMA con-
nector to facilitate the connection to RF test equipment.
Features
♦ Easy Evaluation of MAX2750/MAX2751/MAX2752
♦ +2.7V to +5.5V Single-Supply Operation
♦ RF Output Matched to 50Ω
♦ All Critical Peripheral Components Included
Evaluates: MAX2750/MAX2751/MAX2752
MAX2750/MAX2751/MAX2752 Evaluation Kits
________________________________________________________________ Maxim Integrated Products 1
19-1825; Rev 0; 10/00
Component List
PART
MAX2750EVKIT
MAX2751EVKIT
-40°C to +85°C
-40°C to +85°C
TEMP. RANGE IC-PACKAGE
8 µMAX
8 µMAX
Ordering Information
Component Suppliers
MAX2750EUA, MAX2751EUA, or
MAX2752EUA
1U1
3-pin headers4JU1
SMA connector (PC edge mount)
EFJohnson 142-0701-801
1OUT
1kΩ ±5% resistors (0603)2R1, R2
220pF ±5% ceramic capacitors (0603)
Murata GRM39COH0G221J50
4C2, C3, C4, C5
DESCRIPTIONQTYDESIGNATION
MAX2752EVKIT
-40°C to +85°C 8 µMAX
For price, delivery, and to place orders, please contact Maxim Distribution at 1-888-629-4642,
or visit Maxim’s website at www.maxim-ic.com.
0.1µF ±5% ceramic capacitors (0603)
Taiyo Yuden EMK107BJ104KA
2C1, C6
NOTE: Please indicate that you are using the MAX2750,
MAX2751, or MAX2752 when contacting these component
suppliers.