NLSX4402
www.onsemi.com
12
APPLICATIONS INFORMATION
Level Translator Architecture
The NLSX4402 auto sense translator provides
bi−directional voltage level shifting to transfer data in
multiple supply voltage systems. This device has two
supply voltages, V
L
and V
CC
, which set the logic levels on
the input and output sides of the translator. When used to
transfer data from the V
L
to the V
CC
ports, input signals
referenced to the V
L
supply are translated to output signals
with a logic level matched to V
CC
. In a similar manner, the
V
CC
to V
L
translation shifts input signals with a logic level
compatible to V
CC
to an output signal matched to V
L
.
The NLSX4402 consists of two bi−directional channels
that independently determine the direction of the data flow
without requiring a directional pin. The one−shot circuits
are used to detect the rising or falling input signals. In
addition, the one shots decrease the rise and fall time of the
output signal for high−to−low and low−to−high transitions.
Each input/output channel has an internal 10 kW pull.
The magnitude of the pullup resistors can be reduced by
connecting external resistors in parallel to the internal
10 kW resistors.
Input Driver Requirements
The rise (t
R
) and fall (t
F
) timing parameters of the open
drain outputs depend on the magnitude of the pull−up
resistors. In addition, the propagation times (t
PD
), skew
(t
PSKEW
) and maximum data rate depend on the impedance
of the device that is connected to the translator. The timing
parameters listed in the data sheet assume that the output
impedance of the drivers connected to the translator is less
than 50 kW.
Enable Input (EN)
The NLSX4402 has an Enable pin (EN) that provides
tri−state operation at the I/O pins. Driving the Enable pin
to a low logic level minimizes the power consumption of
the device and drives the I/O V
CC
and I/O V
L
pins to a high
impedance state. Normal translation operation occurs
when the EN pin is equal to a logic high signal. The EN pin
is referenced to the V
L
supply and has Overvoltage
Tolerant (OVT) protection.
Power Supply Guidelines
During normal operation, supply voltage V
L
can be
greater than, less than or equal to V
CC
. The sequencing of
the power supplies will not damage the device during the
power up operation.
For optimal performance, 0.01 mF to 0.1 mF decoupling
capacitors should be used on the V
L
and V
CC
power supply
pins. Ceramic capacitors are a good design choice to filter
and bypass any noise signals on the voltage lines to the
ground plane of the PCB. The noise immunity will be
maximized by placing the capacitors as close as possible to
the supply and ground pins, along with minimizing the
PCB connection traces.
