OMO ElectronicOMO Electronic
Expand menu
Hello, Sign inMy Account
0 Cart

B41570A7688Q000

P1-P3P4-P6P7-P9P10-P12P13-P15P16-P17
Product safety
The table below summarizes the safety instructions that must be observed without fail. A detailed
description can be found in the relevant sections of chapter "General technical information".
Topic Safety information Reference
chapter "General
technical information"
Polarity Make sure that polar capacitors are connected
with the right polarity.
1
"Basic construction of
aluminum electrolytic
capacitors"
Reverse voltage Voltages polarity classes should be prevented by
connecting a diode.
3.1.6
"Reverse voltage"
Mounting
position of screw-
terminal capacitors
Do not mount the capacitor with the terminals
(safety vent) upside down.
11.1.
"Mounting positions of
capacitors with screw
terminals"
Robustness of
terminals
The following maximum tightening torques must
not be exceeded when connecting screw
terminals:
M5: 2.5 Nm
M6: 4.0 Nm
11.3
"Mounting torques"
Mounting of
single-ended
capacitors
The internal structure of single-ended capacitors
might be damaged if excessive force is applied to
the lead wires.
Avoid any compressive, tensile or flexural stress.
Do not move the capacitor after soldering to PC
board.
Do not pick up the PC board by the soldered
capacitor.
Do not insert the capacitor on the PC board with a
hole space different to the lead space specified.
11.4
"Mounting
considerations for
single-ended capacitors"
Soldering Do not exceed the specified time or temperature
limits during soldering.
11.5
"Soldering"
Soldering,
cleaning agents
Do not allow halogenated hydrocarbons to come
into contact with aluminum electrolytic capacitors.
11.6
"Cleaning agents"
Upper category
temperature
Do not exceed the upper category temperature. 7.2
"Maximum permissible
operating temperature"
Passive
flammability
Avoid external energy, such as fire or electricity. 8.1
"Passive flammability"
B41550, B41570
SIKOREL 105 °C
Page 13 of 17Please read Cautions and warnings and
Important notes at the end of this document.
Topic Safety information Reference
chapter "General
technical information"
Active
flammability
Avoid overload of the capacitors. 8.2
"Active flammability"
Maintenance Make periodic inspections of the capacitors.
Before the inspection, make sure that the power
supply is turned off and carefully discharge the
electricity of the capacitors.
Do not apply any mechanical stress to the
capacitor terminals.
10
"Maintenance"
Storage Do not store capacitors at high temperatures or
high humidity. Capacitors should be stored at
+5 to +35 °C and a relative humidity of ≤ 75%.
7.3
Storage conditions
Reference
chapter "Capacitors with
screw terminals"
Breakdown strength
of insulating
sleeves
Do not damage the insulating sleeve, especially
when ring clips are used for mounting.
"Screw terminals
accessories"
B41550, B41570
SIKOREL 105 °C
Page 14 of 17Please read Cautions and warnings and
Important notes at the end of this document.
Symbols and terms
Symbol English German
C Capacitance Kapazität
C
R
Rated capacitance Nennkapazität
C
S
Series capacitance Serienkapazität
C
S,T
Series capacitance at temperature T Serienkapazität bei Temperatur T
C
f
Capacitance at frequency f Kapazität bei Frequenz f
d Case diameter, nominal dimension Gehäusedurchmesser, Nennmaß
d
max
Maximum case diameter Maximaler Gehäusedurchmesser
ESL Self-inductance Eigeninduktivität
ESR Equivalent series resistance Ersatzserienwiderstand
ESR
f
Equivalent series resistance at
frequency f
Ersatzserienwiderstand bei Frequenz f
ESR
T
Equivalent series resistance at
temperature T
Ersatzserienwiderstand bei Temperatur T
f Frequency Frequenz
I Current Strom
I
AC
Alternating current (ripple current) Wechselstrom
I
AC,rms
Root-mean-square value of alternating
current
Wechselstrom, Effektivwert
I
AC,f
Ripple current at frequency f Wechselstrom bei Frequenz f
I
AC,max
Maximum permissible ripple current Maximal zulässiger Wechselstrom
I
AC,R
Rated ripple current Nennwechselstrom
I
AC,R
(B) Rated ripple current for base cooling Nennwechselstromstrom für Bodenkühlung
I
leak
Leakage current Reststrom
I
leak,op
Operating leakage current Betriebsreststrom
l Case length, nominal dimension Gehäuselänge, Nennmaß
l
max
Maximum case length (without
terminals and mounting stud)
Maximale Gehäuselänge (ohne Anschlüsse
und Gewindebolzen)
R Resistance Widerstand
R
ins
Insulation resistance Isolationswiderstand
R
symm
Balancing resistance Symmetrierwiderstand
T Temperature Temperatur
∆T Temperature difference Temperaturdifferenz
T
A
Ambient temperature Umgebungstemperatur
T
C
Case temperature Gehäusetemperatur
T
B
Capacitor base temperature Temperatur des Becherbodens
t Time Zeit
∆t Period Zeitraum
t
b
Service life (operating hours) Brauchbarkeitsdauer (Betriebszeit)
B41550, B41570
SIKOREL 105 °C
Page 15 of 17Please read Cautions and warnings and
Important notes at the end of this document.
P1-P3P4-P6P7-P9P10-P12P13-P15P16-P17

B41570A7688Q000

Mfr. #:
Buy B41570A7688Q000
Manufacturer:
EPCOS / TDK
Description:
Aluminum Electrolytic Capacitors - Screw Terminal 6800UF 40V AL-ELKO SCREW TERM
Lifecycle:
New from this manufacturer.
Delivery:
DHL FedEx Ups TNT EMS
Payment:
T/T Paypal Visa MoneyGram Western Union

Products related to this Datasheet