SpecNo.JENF243J-0011A-01 P4/10
MURATA MFG.CO., LTD
Reference
Only
8.Environmental Performance (It shall be soldered on the substrate.)
No. Item Specification Test Method
8.1 Heat Resistance Appearance: No damage
Impedance Change: within ± 10%
DC Resistance Change: within ± 10%
Temperature: 105±2°C
Time: 1000± hours
Then measured after exposure in the room condition
for 24±2 hours.
8.2 Cold Resistance Temperature: -40±2°C
Time: 1000± hours
Then measured after exposure in the room condition
for 24±2 hours.
8.3 Humidity Temperature: 40±2°C
Humidity: 90~95%(RH)
Time: 1000± hours
Then measured after exposure in the room condition
for 24±2 hours.
8.4 Temperature
Cycle
1 cycle:
1 step: -40±2°C / 30±3 min
2 step: Ordinary temp. / 10 to 15 min
3 step: +105±2°C / 30±3 min
4 step: Ordinary temp. / 10 to 15 min
Total of 10 cycles
Then measured after exposure in the room condition
for 24±2 hours.
9. Specification of Packaging
9.1 Appearance and Dimensions of plastic tape
(in mm)
9.2 Specification of Taping
(1) Packing quantity (standard quantity)
φ180 mm reel : 500 pcs. / reel
φ330 mm reel : 3000 pcs. / reel
(2) Packing Method
Products shall be packed in the each embossed cavity of plastic tape and sealed by cover tape.
(3) Sprocket hole
The sprocket holes are to the right as the tape is pulled toward the user.
(4) Spliced point
Plastic tape and Cover tape has no spliced point.
(5) Missing components number
Missing components number within 0.1 % of the number per reel or 1 pc., whichever is greater,
and are not continuous. The specified quantity per reel is kept.
9.3 Pull Strength
Embossed carrier tape 10N min.
Cover tape 5N min.
48
0
48
0
48
0
Dimension of the Cavity is measured
at the bottom side.
5.3±0.1
2.0±0.05 4.0±0.1
Direction of
feed
2.4±0.1
*Lead-in/out wire
φ 1.5
-0
+0.1
(0.3)
8.0±0.1
5.3±0.1
12.0±0.2
5.5±0.05
1.75±0.1
