DATA SHEET
SE2597L: 2.4 GHz Power Amplifier with Power Detector
Preliminary Information
Skyworks Solutions, Inc. • Phone [781] 376-3000 • Fax [781] 376-3100 • sales@skyworksinc.com • www.skyworksinc.com
202434A • Skyworks Proprietary Information • Products and Product Information are Subject to Change Without Notice • September 25, 2012 3
Absolute Maximum Ratings
These are stress ratings only. Exposure to stresses beyond these maximum ratings for a long period of time may
cause permanent damage to, or affect the reliability of the device. Avoid operating the device outside the
recommended operating conditions defined below. This device is ESD sensitive. Handling and assembly of this
device should be at ESD protected workstations.
Symbol Definition Min. Max. Unit
VCC Supply Voltage on pins VCC -0.3 4 V
RFout
Supply Voltage on pins VCC3 (Note: SE2597L
application circuit must be followed for operation above
3.6 V)
-0.3 5.5 V
VEN Power Amplifier Enable -0.3 3.6 V
RFin RF Input Power, RF_OUT terminated into 50Ω match - 10 dBm
TSTG Storage Temperature Range -40 150 °C
ESD
HBM
JEDEC JESD22-A114
all pins
- 500 V
Recommended Operating Conditions
Symbol Parameter Min. Max. Unit
VCC Supply Voltage 3.0 3.6 V
VCC3 Supply Voltage on pins VCC3 3.0 3.6 V
TA Ambient Temperature -40 85 °C
DC Electrical Characteristics
Conditions: VCC
= V
CC3 = VEN = 3.3 V, TA = 25 °C, as measured on Skyworks Solutions’ SE2597L-EV1 evaluation
board, unless otherwise noted.
Symbol Parameter Conditions Min. Typ. Max. Unit
ICC-802.11b
Supply Current
(Sum of V
CC0, VCC, VCC3)
POUT = 23 dBm, 11 Mbps CCK
signal, BT = 0.45, V
CC = VCC3 = 3.3
V
- 250 - mA
ICC-802.11g
Supply Current (Sum of
V
CC,VCC3)
P
OUT
= 19 dBm, 54 Mbps OFDM
signal, 64 QAM, VCC = VCC3 = 3.3 V
- 175 - mA
I
CQ
Supply Current
(Sum of V
CC,VCC3)
No RF - 125 - mA
IOFF Supply Current VEN = 0 V, No RF - 2 10 μA
VENH Logic High Voltage - 1.3 - VCC V
VENL Logic Low Voltage - 0 - 0.5 V
IENH
Input Current Logic
High Voltage
- - 300 - μA
