323
Amphenol Corporation Tel: 800-627-7100 www.amphenolrf.com
Assembly
CRIMP-CRIMP TYPES FOR FLEXIBLE CABLE
Step 1
.
Step 2
Step 3
Step 1 Slide heat shrink tubing and outer ferrule onto cable. Strip
cable jacket, braid and dielectric to dimensions shown in
table above. All cuts are to be sharp and square. Do not nick
braid, dielectric or center conductor when cutting. Flare end of
cable braid slightly as shown to facilitate insertion of inner
ferrule. Do not comb out braid.
Step 2 For crimp contact type only:
Crimp center contact to cable conductor using 8-indent Tool
and Positioner shown in Table above. Note: Contact must
bottom against cable dielectric.
*For solder type connectors:
Solder contact to center conductor.
Step 3 Install inner ferrule of body assembly over cable dielectric
and under braid. Place outer ferrule against body and crimp
with tool 227-944 (M22520/5-01) and die set shown in table
above. Place heat shrink tubing over crimp ferrule, against
body, and apply heat.
Amphenol Connector Cable
Stripping Dimensions, inches (mm) Contact Data Outer Ferrule Data
CTL
Number Type RG-/U
ab c
Positioner for Positioner for Hex Cav. for Die Set for Series
Tool 227-1454 M22520/1-01 Outer ferrule Tool 227-944 Tool
901-101-15* SMA Plug 142B, 400 .531(13.5) .250(3.2) .141(3.6) — /1-15 .213(5.4) 227-1221-11 Cav. A CTL-1
901-9511-1SFC SMA Plug 55, 58, 141, .300(7.6) — .090(2.3) 227-1451-1 — .213(5.4) 227-1221-11 Cav. A CTL-1
142, 223, 400
901-9511-3* SMA Plug 174, 179B, .470(11.9) .170(4.3) .120(3.0) 227-1451-1 — .128(3.3) 227-1221-03
CTL-13;9
901-9511-3SF* SMA Plug 187A, 316 .470(11.9) .170(4.3) .120(3.0) 227-1451-1 — .128(3.3) 227-1221-03
CTL-13;9
901-9511-3SFC SMA Plug 174, 179, 187 .470(11.9) .170(4.3) .120(3.0) 227-1451-1 — .128(3.3) 227-1221-03
CTL-13;9
188, 316
901-9511-12SF* SMA Plug Dbl. Br. 316 .470(11.9) .170(4.3) .120(3.0) 227-1451-1 — .151(3.8) 227-1221-37 Cav. B
CTL-13;9
901-9511-12SFC SMA Plug Dbl. Br. 316 .470(11.9) .170(4.3) .120(3.0) 227-1451-1 — .151(3.8) 227-1221-37 Cav. B
CTL-13;9
