4
FN7186.8
October 15, 2015
IMPORTANT NOTE: All parameters having Min/Max specifications are guaranteed. Typ values are for information purposes only. Unless otherwise noted, all tests are
at the specified temperature and are pulsed tests, therefore: T
J
= T
C
= T
A
Absolute Maximum Ratings (T
A
= +25°C) Thermal Information
Supply Voltage between V
S
+ and V
S
- . . . . . . . . . . . . . . . . . . . .+18V
Input Voltage . . . . . . . . . . . . . . . . . . . . . . . . . . V
S
- - 0.5V, V
S
+0.5V
Maximum Continuous Output Current . . . . . . . . . . . . . . . . . . . 30mA
Thermal Resistance (Typical)
JA
(°C/W)
5 Ld TSOT (Note 5) . . . . . . . . . . . . . . . . . . . . . . . . . 214
8 Ld DFN (Note 6) . . . . . . . . . . . . . . . . . . . . . . . . . . 55
8 Ld MSOP (Note 5). . . . . . . . . . . . . . . . . . . . . . . . . 115
16 Ld QFN (Note 6) . . . . . . . . . . . . . . . . . . . . . . . . . 44
14 Ld SOIC (Note 5) . . . . . . . . . . . . . . . . . . . . . . . . 82
14 Ld TSSOP (Note 5) . . . . . . . . . . . . . . . . . . . . . . . 93
Storage Temperature . . . . . . . . . . . . . . . . . . . . . . . .-65°C to +150°C
Operating Junction Temperature Range . . . . . . . . . . -40°C to +125°
Power Dissipation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . See Curves
Pb-Free Reflow Profile. . . . . . . . . . . . . . . . . . . . . . . . .see link below
http://www.intersil.com/pbfree/Pb-FreeReflow.asp
CAUTION: Do not operate at or near the maximum ratings listed for extended periods of time. Exposure to such conditions may adversely impact product reliability and
result in failures not covered by warranty.
NOTES:
5.
JA
is measured with the component mounted on a high effective thermal conductivity test board in free air. See Tech Brief TB379 for details.
6.
JA
is measured in free air with the component mounted on a high effective thermal conductivity test board with “direct attach” features. See
Te ch B ri ef TB379
.
Electrical Specifications V
S
+
= +5V, V
S
-
= -5V, R
L
= 10k and C
L
= 10pF to 0V, T
A
= +25°C, unless otherwise specified.
PARAMETER DESCRIPTION CONDITIONS MIN TYP MAX UNIT
INPUT CHARACTERISTICS
V
OS
Input Offset Voltage V
CM
= 0V 2 12 mV
TCV
OS
Average Offset Voltage Drift (Note 7) 5 µV/°C
I
B
Input Bias Current V
CM
= 0V 2 50 nA
R
IN
Input Impedance 1G
C
IN
Input Capacitance 1.35 pF
CMIR Common-Mode Input Range -5.5 +5.5 V
CMRR Common-Mode Rejection Ratio for V
IN
from -5.5V to +5.5V 50 70 dB
A
VOL
Open Loop Gain -4.5V V
OUT
4.5V 75 95 dB
OUTPUT CHARACTERISTICS
V
OL
Output Swing Low I
L
= -5mA -4.92 -4.85 V
V
OH
Output Swing High I
L
= 5mA 4.85 4.92 V
I
SC
Short Circuit Current ±120 mA
I
OUT
Output Current ±30 mA
POWER SUPPLY PERFORMANCE
PSRR Power Supply Rejection Ratio V
S
is moved from ±2.25V to ±7.75V 60 80 dB
I
S
Supply Current (Per Amplifier) No load 500 750 µA
DYNAMIC PERFORMANCE
SR Slew Rate (Note 8) -4.0V V
OUT
4.0V, 20% to 80% 10 V/µs
t
S
Settling to +0.1% (A
V
= +1) (A
V
= +1), V
O
= 2V step 500 ns
BW -3dB Bandwidth R
L
= 10k, C
L
= 10pF 12 MHz
GBWP Gain-Bandwidth Product R
L
= 10k, C
L
= 10pF 8 MHz
PM Phase Margin R
L
= 10k, C
L
= 10pF 50 °
CS Channel Separation f = 5MHz (EL5220 and EL5420 only) 75 dB
NOTES:
7. Measured over operating temperature range.
8. Slew rate is measured on rising and falling edges.
EL5120, EL5220, EL5420
