4
FN7330.3
May 3, 2007
Absolute Maximum Ratings (T
A
= +25°C) Thermal Information
Supply Voltage between V
S
+ and V
S
-. . . . . . . . . . . . . . . . . . . 13.2V
Input Voltage . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .±V
S
Differential Input Voltage . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .±4V
Maximum Output Current. . . . . . . . . . . . . . . . . . . . . . . . . . . . . 80mA
Maximum Slewrate from V
S
+ to V
S
- . . . . . . . . . . . . . . . . . . . . 1V/µs
Storage Temperature Range . . . . . . . . . . . . . . . . . .-65°C to +150°C
Ambient Operating Temperature Range . . . . . . . . . .-40°C to +85°C
Operating Junction Temperature . . . . . . . . . . . . . . . . . . . . . . +150°C
Pb-free reflow profile . . . . . . . . . . . . . . . . . . . . . . . . . .see link below
http://www.intersil.com/pbfree/Pb-FreeReflow.asp
CAUTION: Stresses above those listed in “Absolute Maximum Ratings” may cause permanent damage to the device. This is a stress only rating and operation of the
device at these or any other conditions above those indicated in the operational sections of this specification is not implied.
IMPORTANT NOTE: All parameters having Min/Max specifications are guaranteed. Typical values are for information purposes only. Unless otherwise noted, all tests
are at the specified temperature and are pulsed tests, therefore: T
J
= T
C
= T
A
DC Electrical Specifications V
S
= ±5V, GND = 0V, T
A
= +25°C, V
CM
= 0V, V
OUT
= 0V, V
ENABLE
= GND or OPEN, Unless Otherwise
Specified.
PARAMETER DESCRIPTION CONDITIONS MIN TYP MAX UNIT
V
OS
Offset Voltage -4 1 4 mV
TCV
OS
Offset Voltage Temperature Coefficient Measured from T
MIN
to T
MAX
8µV/°C
IB Input Bias Current V
IN
= 0V -6 2 6 µA
I
OS
Input Offset Current V
IN
= 0V -2.5 0.5 2.5 µA
TCI
OS
Input Bias Current Temperature
Coefficient
Measured from T
MIN
to T
MAX
8nA/°C
PSRR Power Supply Rejection Ratio 70 90 dB
CMRR Common Mode Rejection Ratio V
CM
from -3V to +3V 60 75 dB
CMIR Common Mode Input Range Guaranteed by CMRR test -3 +3 V
R
IN
Input Resistance V
IN
= -3V to +3V 0.7 1.2 MΩ
C
IN
Input Capacitance 1pF
I
S,ON
Supply Current - Enabled Per amplifier 2.1 2.5 2.9 mA
I
S,OFF
Supply Current - Shut Down V
S
+, per amplifier -5 0 5 µA
V
S
-, per amplifier 5 17 25 µA
PSOR Power Supply Operating Range 3.3 12 V
AVOL Open Loop Gain R
L
= 1kΩ to GND, V
OUT
from -2.5V to +2.5V 55 60 dB
V
OP
Positive Output Voltage Swing R
L
= 150Ω to GND 3.2 3.4 V
R
L
= 1kΩ to GND 3.6 3.8 V
V
ON
Negative Output Voltage Swing R
L
= 150Ω to GND -3.4 -3.2 V
R
L
= 1kΩ to GND -3.8 -3.6 V
I
OUT
Output Current R
L
= 10Ω to 0V ±60 ±100 mA
V
IH-EN
ENABLE pin Voltage for Power Up V
S
+ -4 V
V
IL-EN
ENABLE pin Voltage for Shut Down V
S
+ -1 V
I
EN
Enable Pin Current Enabled, V
EN
= 0V -1 1 µA
Disabled, V
EN
= 5V 5 17 25 µA
EL5100, EL5101, EL5300