Propeller ASC+
Item code 32214
The Propeller ASC+ is an Arduino Shield Compatible
prototyping system
designed to use existing Arduino add-on boards with the Propeller's SPIN
language, Propeller Assembly, C and C++. You now have the power of truly
simultaneous processing at your fingertips to use with your existing Arduino
shields, and do
’t have to start over with new boards and setups. Simply attach
our shields to this board, and you will be up and running in no time.
Switching to the Propeller Multicore Processor and giving your project the
pper hand has never been easier for Arduino shield based projects.
ey Features
Can be powered from the USB port (500mA polyfuse) or with 6-9 v 2.1
mm power jack, allowing for rapid proto-typing
3.3 v and 5 v voltage regulators allow you to integrate a wide variety of
sensors
Mini-USB interface means no searching for a special cable to connect
with your computer
Specifications
3.3 v AUX port for extra digital I/O or TV/keyboard/mouse or RGB
using only a few resistors
MCP3208 12-bit analog to digital converter
Fourteen Arduino compatible, current protected 3.3 v digital I/O pins
PWM, I2C, SPI, UART and more, in any combination on any pin.
64 KB EEPROM (32 K for program + 32 K for data storage)
Dimensions: 2.70 x 2.10 in (68.6 x 53.3 mm)
ARNING
Pins P16 through P23 are not protected! Do not apply above 3.3
olts to these
ins!
Page 1 of 1Propeller ASC
4
2
201
htt
://www.
arallax.com/StoreSearchResults/tabid/768/txtSearch/32214/List/0/SortField/4/ProductID/872/Default....
