MAX4028/MAX4029
Although the MAX4028/MAX4029 are optimized for AC
performance and are not designed to drive highly
capacitive loads, they are capable of driving up to
15pF without oscillations. However, some peaking may
occur in the frequency domain (Figure 4). To drive larg-
er capacitive loads or to reduce ringing, add an isola-
tion resistor between the amplifier’s output and the load
(Figure 5). The value of R
ISO
depends on the circuit’s
gain (+2V/V) and the capacitive load (Figure 6). Also
note that the isolation resistor forms a divider that
decreases the voltage delivered to the load.
Layout and Power-Supply Bypassing
The MAX4028/MAX4029 have high bandwidths and
consequently require careful board layout, including
the possible use of constant-impedance microstrip or
stripline techniques.
To realize the full AC performance of these high-speed
amplifiers, pay careful attention to power-supply
bypassing and board layout. The PC board should
have at least two layers: a signal and power layer on
one side, and a large, low-impedance ground plane on
the other side. The ground plane should be as free of
voids as possible. Whether or not a constant-imped-
ance board is used, it is best to observe the following
guidelines when designing the board:
1) Do not use wire-wrapped boards or breadboards.
2) Do not use IC sockets; they increase parasitic
capacitance and inductance.
3) Keep signal lines as short and straight as possible.
Do not make 90° turns; round all corners.
4) Observe high-frequency bypassing techniques to
maintain the amplifier’s accuracy and stability.
5) Use surface-mount components. They generally
have shorter bodies and lower parasitic reactance,
yielding better high-frequency performance than
through-hole components.
Triple/Quad, 2:1 Video
Multiplexer-Amplifiers with Input Clamps
10 ______________________________________________________________________________________
