43
030917
TAJ Series
Low Profile
RATINGS & PART NUMBER REFERENCE
Rated Rated Category Category DCL DF
ESR
100kHz RMS Current (mA)
AVX Case Capacitance
Voltage Temperature Voltage Temperature Max. Max.
Max.
MSL
Part No. Size (μF)
(V) (ºC) (V) (ºC) (μA) (%)
@ 100kHz
25ºC 85ºC 125ºC
(Ω)
TAJS334*050#NJ S 0.33 50 85 33 125 0.5 4 11 1 77 69 31
TAJT334*050#NJ T 0.33 50 85 33 125 0.5 4 11 1 85 77 34
TAJS474*050#NJ S 0.47 50 85 33 125 0.5 4 9.5 1 83 74 33
TAJT474*050#NJ T 0.47 50 85 33 125 0.5 4 9.5 1 92 83 37
TAJW105*050#NJ W 1 50 85 33 125 0.5 6 4.4 1 143 129 57
TAJW155*050#NJ W 1.5 50 85 33 125 0.8 6 3.1 1 170 153 68
TAJW225*050#NJ W 2.2 50 85 33 125 1.1 8 2.5 1 190 171 76
TAJY335*050#NJ Y 3.3 50 85 33 125 1.7 4 1.5 1
1)
289 260 115
TAJX475*050#NJV X 4.7 50 85 33 125 2.4 6 1.0 3 316 285 126
TAJY475*050#NJ Y 4.7 50 85 33 125 2.4 6 1.2 1
1)
323 290 129
TAJY685*050#NJ Y 6.8 50 85 33 125 3.4 6 0.9 1
1)
373 335 149
QUALIFICATION TABLE
TEST
TAJ low profile series (Temperature range -55ºC to +125ºC)
Condition Characteristics
Visual examination no visible damage
DCL 1.25 x initial limit
Endurance ΔC/C within ±10% of initial value
DF initial limit
Visual examination no visible damage
DCL initial limit
Humidity ΔC/C within ±10% of initial value
DF 1.2 x initial limit
+20ºC -55ºC +20ºC +85ºC +125ºC +20ºC
Temperature DCL
IL* n/a IL* 10 x IL* 12.5 x IL* IL*
Stability ΔC/C
n/a +0/-10% ±5% +10/-0% +12/-0% ±5%
DF
IL* 1.5 x IL* IL* 1.5 x IL* 2 x IL* IL*
Visual examination no visible damage
Surge
DCL initial limit
Voltage
ΔC/C within ±5% of initial value
DF initial limit
Determine after application of rated voltage for 2000
+48/-0 hours at 85±2ºC and then leaving 1-2 hours at
room temperature. Also determine of 125ºC tempera-
ture, category voltage for 2000 +48/-0 hours and
then leaving 1-2 hours at room temperature. Power
supply impedance to be ≤0.1Ω/V.
Determine after storage without applied voltage
at 65±2ºC and 95±2% relative humidity for 500
hours and then recovery 1-2 hours at room
temperature.
Test temperature: 125ºC+3/0ºC
Test voltage: Category voltage at 125ºC
Surge voltage: 1.3 x category voltage at 125ºC
Series protection resistance 1000±100Ω
Discharge resistance: 1000Ω
Number of cycles: 1000x
Cycle duration: 6 min; 30 sec charge,
5 min 30 sec discharge
Step Temperature°C Duration(min)
1 +20±2 15
2 -55+0/-3 15
3 +20±2 15
4 +85+3/-0 15
5 +125+3/-0 15
6 +20±2 15
*Initial Limit
1
1)
– Dry pack option (see How to order) recommended for reduction of stress during soldering. Dry pack parts should be treated as MSL 3.
Moisture Sensitivity Level (MSL) is defined according to J-STD-020.
All technical data relates to an ambient temperature of +25°C. Capacitance and DF are measured at 120Hz, 0.5V RMS with a maximum DC bias of 2.2 volts. DCL is
measured at rated voltage after 5 minutes.
For typical weight and composition see page 227.
NOTE: AVX reserves the right to supply a higher voltage rating or tighter tolerance part in the same case size, to the same reliability standards.
