12/19/2013 1 www.onsemi.com
Test Procedure for the LV5693PGEVB Evaluation Board
TEST Procedure
Prepare “DC POWER SUPPLY’’, capability is 40V or more and 4A or more. And “Digital
MULTIMETER”, and “ELECTRIC DC LOAD”
1. Initial Setting.
Refer to Fig1, In initial setting, “USB_EN”,
”EXT_EN”, “AUDIO/DSP_EN”, “ILM_EN”, “CD_EN”
pins are shorted GND.
And ILM, CD, AUDIO, DSP and EXT are low potential.
2. Measurement.
Connect VCC/VCC1 cable and GND cable.
Bias VCC/VCC1 voltage. Regarding bias voltage
range, refer to Application note. Next step remove
3 “Shorted Ring”. Then measure each ILB, CD
AUDIO, DSP, EXT, VDD of voltage and Iq at no load. And then
Refer to below the descriptive text others characteristic of measurement.
Line regulation
Line regulation is defined as the maximum change in output voltage as the input voltage is varied
through the specified range. It is measured by changing the input voltage and measuring the
minimum/maximum voltage of the output. Line regulation is defined as the difference between
maximum and minimum voltage.
Load regulation
Load regulation is defined as the maximum change in output voltage as the load current is varied
through the specified range. It is measured by changing the load current and measuring the
minimum/maximum voltage of the output. Load regulation is defined as the difference between
maximum and minimum voltage.
Dropout voltage
Dropout voltage is defined as the minimum input-to-output differential voltage at the specified load
current required by the regulator to keep the output voltage in regulation. It is measured by reducing
input voltage until the output voltage drops below the nominal value.
Ripple rejection
Ripple rejection is defined as the ratio of input ripple amplitude versus that of output.
Note: Please refer to datasheet table for electrical characteristics acceptable tolerances.
