DATASHEET
SMD PLCC
EAHC2835WD1
16
Copyright © 2015,
Everlight Americas Inc
. Release Date : 31.Aug 2015. Issue No:
Issue No:DSE-00
www.everlightamericas.com
Precautions for Use
1. Over-current-proof
Customer must apply resistors for protection; otherwise slight voltage shift will cause big current change (Burn out
will happen).
2. Storage
2.1 Do not open moisture proof bag before the products are ready to use.
2.2 Before opening the package: The LEDs should be kept at 30 or less and 90%RH or less.
2.3 After opening the package: The LED's floor life is 168 Hrs under 30 or less and 60% RH or less. If unused
LEDs remain, it should be stored in moisture proof packages.
2.4 If the moisture absorbent material (silica gel) has faded away or the LEDs have exceeded the storage time,
baking treatment should be performed using the following conditions.
Baking treatment: 60±5 for 24 hours.
3. Soldering Condition
3.1 Pb-free solder temperature profile
3.2 Reflow soldering should not be done more than two times.
3.3 When soldering, do not put stress on the LEDs during heating.
3.4 After soldering, do not warp the circuit board.
