RACD35-A
LIGHTLINE
AC/DC-Converter
with 5 year Warranty
35 Watt PFC
Single
Output
Selection Guide
Description
Input Voltage Range 90-305 VAC
Input Frequency Range 47-63Hz
Power Factor Full Load, 277VAC >0.90
Full Load, 230VAC >0.95
Full Load, 110VAC >0.98
AC Input Current 110VAC 0.5A
230VAC 0.3A
Inrush Current (Max.) 264VAC Cold Start 60A
Leakage Current 230VAC <0.25mA
Output Current Accuracy (includes Line Regulation, Load Regulation and set-up tolerance) ±5%
Isolation Voltage 3.75kVAC / 1minute
Short Circuit Protection Hiccup mode & recovers after fault condition removed
Over Voltage Protection 115% - 135% Output Voltage Latch Mode
Over Temperature Protection Thermistor 105°C ± 10°C
Type Latch Mode
Dimming Control: PWM 1<Adj<10V(500Hz - 3kHz)
Analogue control by external voltage 1-10VDC
Resistance 10K - 100KΩ
Set Up Time Full Load, 230VAC 2 sec
Storage Humidity 10% - 95% RH
Operating Humidity 20% - 95% RH Non-Condensing
Weight 384g
Dimension (LxBxH) 110 x 73.5 x 33mm
Operating Temperature Range Full load -20°C to +50°C
(free air convection - 10LFM) Case Temperature 85°C ± 10°C
Storage Temperature -40°C to +80°C
IP Rating IP67
Isolation Resistance 500VDC 100MΩ
MTBF (+25°C) using MIL-HDBK 217F 200 x 10³ hours
Certifications:
UL Standards Report: E340696 UL8750, (based on) UL1310
Safety Standards Report: P201403013 EN61347-1; EN61347-2-13
continued on next page
Specifications (measured at 240VAC and 25°C ambient temperature)
● 35W Class II AC-DC LED Power Supply
●
500, 700, 1000, 1400mA or 2500mA Output
● Active Power Factor Correction >0.90
●
Efficiency up to 83%
●
IP67 Certified
● 3 in 1 Dimming
Features
LED DRIVER
Part Rated Output Output Efficiency
Number Power Current Voltage (typ.)
(W) (mA) (VDC) (%)
RACD35-500A 28.5 500 48 - 57 82
RACD35-700A 33,6 700 33 - 48 79
RACD35-1000A 36 1000 24 - 36 82
RACD35-1400A 33.6 1400 12 - 24 81
RACD35-2500A 30 2500 9 - 12 80
UL8750 Certified
EN61347 Certified
EN55015 Certified
EN61547 Certified
RoHS
2011/65/EU
6/6
E340696
Refer to Application Notes
Note:
All LED Drivers may not be used without a
load. They must be switched on the primary
side only. Noncompliance may damage the
LED or reduce its lifetime.
The 35W LED drivers of the RACD35-A series come with a 3-in-1 dimming function so that the LED load can
be dimmed with analog (1-10V), PWM, or resistor inputs. Due to wide input voltage range of 90 - 305VAC
these LED drivers are suitable for worldwide use. They operate with efficiencies of up to 83%, feature active
PFC, and are fully protected against short circuit, overvoltage, and over-temperature conditions.
They are sealed against damp and wet conditions, and the warranty is 5 years.
Derating-Graph
(Ambient Temperature)
L-46 www.recom-power.comREV: 0/2015
