3
Figure 3. Complete attachment between Collimator Lens and ASMT-Mxxx
unit
Hold the lens by position A & B and make sure that the
lens is perpendicular to the unit top surface as shown in
Figure 2.
Surface C and D of the Collimator Lens have to be pressed
perpendicularly onto the flange surface of E and F until
the hard stop.
Figure 2. Attachment between collimator lens and unit.
Figure 1. Collimator Lens ASMT-M0xx and ASMT-Mxxx unit
Application of Collimator Lens
Lens Attachment
Lens attachment to the unit is through “press-fitting”. To
make sure that the lens is properly attached, the lens
need to be press-fitted until it reaches a hard stop at the
top surface of the unit.
Flange
Collimator Lens
Metal Slug
A
B
C
D
Hard Stop Line
E
F
90°
Collimator Lens
ASMT-M0xx
Power LED
ASMT-Mxxx
Precaution
This lens is designed for press-fitting only. Do not over-
press the lens while attaching both lens and unit. No
adhesive and/or lubricant is applicable for this applica-
tion. Avoid using corrosive chemical to clean the lens. Use
only Iso Propyl Alcohol (IPA) for this purpose.