J
Series HP02
6mm Tactiles
www.nkk.com
J12
Indicators
AccessoriesSupplement
Tactiles
KeylocksRotaries
Pushbuttons
Illuminated PB
Slides
Programmable
Rockers
Touch Tilt
Toggles
Electrical Capacity (Resistive Load)
Power Level (silver): 3VA maximum @ 28V DC maximum
(Applicable Range 10mA ~ 125mA @ 0.1V ~ 28V)
Logic Level (gold): 0.4VA maximum @ 28V AC/DC maximum
(Applicable Range 0.1mA ~ 0.1A @ 20mV ~ 28V)
Note: See Supplement for further explanation of operating range.
Other Ratings
Contact Resistance: 100 milliohms maximum
Insulation Resistance: 100 megohms minimum @ 100V DC
Dielectric Strength: 250V AC minimum for 1 minute minimum between contacts & between contacts & case
Mechanical Life: 500,000 operations minimum
Electrical Life: 500,000 operations minimum
Nominal Operating Force: 1.60N
Total Travel: .008” (0.2mm)
Materials & Finishes
Actuator: Glass fiber reinforced polyamide (UL94V-0)
Case: Stainless steel
Base: Glass fiber reinforced polyamide (UL94V-0)
Movable Contacts: Stainless steel with silver or gold plating
Stationary Contacts: Brass with silver or gold plating
Terminals: Brass with silver or gold plating
Environmental Data
Operating Temperature Range: –20°C through +70°C (–4°F through +158°F)
Humidity: 90 ~ 95% humidity for 240 hours @ 40°C (104°F)
Vibration: 10 ~ 55Hz with peak-to-peak amplitude of 1.5mm traversing the frequency range & returning
in 1 minute; 3 right angled directions for 2 hours
Shock: 100G (981m/s
2
) acceleration (tested in 6 right angled directions, with 5 shocks in each direction)
PCB Processing
Soldering: Wave Soldering Recommended. See Profile A in Supplement section.
Manual Soldering: See Profile A in Supplement section.
Cleaning: These devices are not process sealed. Hand clean locally using alcohol based solution.
Standards & Certifications
Flammability Standards: UL94V-0 actuator and base
These switches are designed for use in a low-voltage, low-current circuit.
When used as intended, the results do not produce hazardous energy.
General Specifications
