PIC18F66K80 FAMILY
DS30509A-page 10 2012 Microchip Technology Inc.
3.2 DC Characteristics: Supply Voltage (High Temperature)
PIC18F66K80 Family
(High Temperature)
Standard Operating Conditions (unless otherwise stated)
Operating temperature +125°C T
A +150°C for high temperature
Param
No.
Symbol Characteristic Min Typ Max Units Conditions
D001 V
DD Supply Voltage 4.0 — 5.5 V For F devices
3.3 DC Characteristics: Power Down and Supply Current (High Temperature)
PIC18F66K80 Family
(High Temperature)
Standard Operating Conditions (unless otherwise stated)
Operating temperature +125°C T
A +150°C for high temperature
Param
No.
Device Typ Max Units Conditions
PIC18FXXK80 Power-Down Current (I
PD)
(1)
10 28 µA +150°C VDD = 5V, Sleep mode
Module Differential Currents
12 29 µA +150°C V
DD = 5V,
Watchdog Timer Current: ΔI
WDT
12 28 µA +150°C V
DD = 5V, A/D Current: ΔIAD
12 28 µA +150°C VDD = 5V,
High/Low-Voltage Detect: ΔI
HLVD
Supply Current (IDD)
(2,3)
10 32 mA +150°C VDD = 5V, FOSC = 64 MHz
(PRI_RUN mode)
—8mA+150°CV
DD = 5V, FOSC = 4 MHz
(PRI_RUN mode)
—3mA+150°CV
DD = 5V, FOSC = 1 MHz
(PRI_RUN mode)
—8mA+150°CV
DD = 5V, FOSC = 64 MHz
(PRI_IDLE mode)
—1.8mA+150°CV
DD = 5V, FOSC = 4 MHz
(PRI_IDLE mode)
—1mA+150°CV
DD = 5V, FOSC = 1 MHz
(PRI_IDLE mode)
— 28 mA +150°C V
DD = 5V, FOSC = 64 MHz
(PRI_RUN mode, 16 MHz w/PLL)
—8mA+150°CV
DD = 5V, FOSC = 16 MHz
(PRI_RUN mode, 4 MHz w/PLL)
Note 1: The power-down current in Sleep mode does not depend on the oscillator type. Power-down current is
measured with the part in Sleep mode, with all I/O pins in a high-impedance state and tied to VDD or VSS,
and all features that add delta current are disabled (such as WDT, secondary oscillator, BOR, etc.).
2: The supply current is mainly a function of operating voltage, frequency and mode. Other factors, such as
I/O pin loading and switching rate, oscillator type and circuit, internal code execution pattern and
temperature, also have an impact on the current consumption.
3: The test conditions for all I
DD measurements in active operation mode are:
OSC1 = External square wave, from rail-to-rail; all I/O pins tri-stated, pulled to V
DD;
MCLR
= VDD; WDT is enabled/disabled as specified.
