Package ORDERING INFORMATION: SMD Number
01 16 pin CERDIP MAX232MJE/883B 5962-8987701EA
01 20 pin LCC MAX232MLP/883B 5962-89877012C
02 20 pin CERDIP MAX230MJP/883B 5962-8987702RA
03 14 pin CERDIP MAX231MJD/883B 5962-8987703CA
04 16 pin CERDIP MAX234MJE/883B 5962-8987704EA
05 24 pin CERDIP MAX236MRG/883B 5962-8987705JA
06 24 pin CERDIP MAX237MRG/883B 5962-8987706JA
07 24 pin CERDIP MAX238MRG/883B 5962-8987707JA
08 24 pin CERDIP MAX239MRG/883B 5962-8987708JA
QUALITY ASSURANCE
Sampling and inspection procedures shall be in accordance with MIL-Prf-38535, Appendix A as specified in Mil-
Std-883.
Screening shall be in accordance with Method 5004 of Mil-Std-883. Burn-in test Method 1015:
1. Test Condition, A, B, C, or D.
2. TA = +125°C minimum.
3. Interim and final electrical test requirements shall be specified in Table 2.
Quality conformance inspection shall be in accordance with Method 5005 of Mil-Std-883, including Groups A, B,
C, and D inspection.
Group A inspection:
1. Tests as specified in Table 2.
2. Selected subgroups in Table 1, Method 5005 of Mil-Std-883 shall be omitted.
Group C and D inspections:
a. End-point electrical parameters shall be specified in Table 1.
b. Steady-state life test, Method 1005 of Mil-Std-883:
1. Test condition A, B, C, D.
2. TA = +125°C, minimum.
3. Test duration, 1000 hours, except as permitted by Method 1005 of Mil-Std-883.
TABLE 2. ELECTRICAL TEST REQUIREMENTS
Mil-Std-883 Test Requirements Subgroups
per Method 5005, Table 1
Interim Electric Parameters
Method 5004
1
Final Electrical Parameters
Method 5005
1*, 2, 3, 9, 10, 11
Group A Test Requirements
Method 5005
1, 2, 3, 9, 10, 11
Group C and D End-Point Electrical Parameters
Method 5005
1
* PDA applies to Subgroup 1 only.
---------------------------- Electrical Characteristics of MAX230/231/232/234/236 19-0325 Rev. B
237/238/239/883B and SMD 5962-89877 Page 5 of 6
