LTC3026-1
11
30261f
OPERATION
Short-Circuit/Thermal Protection
The LTC3026-1 has built-in output short-circuit current
limiting as well as overtemperature protection. During
short-circuit conditions, internal circuitry automatically
limits the output current to approximately 3A. At higher
temperatures, or in cases where internal power dissipa-
tion cause excessive self heating on-chip, the thermal
shutdown circuitry will shut down the boost converter and
LDO when the junction temperature exceeds approximately
150°C. It will reenable the converter and LDO once the
junction temperature drops back to approximately 140°C.
The LTC3026-1 will cycle in and out of thermal shutdown
without latchup or damage until the overstress condition
is removed. Long term overstress (T
J
> 125°C) should
be avoided as it can degrade the performance or shorten
the life of the part.
Reverse Input Current Protection
The LTC3026-1 features reverse input current protection to
limit current draw from any supplementary power source
at the output. Figure 6 shows the reverse output current
limit for constant input and output voltages cases. Note:
Positive input current represents current flowing into the
V
IN
pin of LTC3026-1.
With V
OUT
held at or below the output regulation voltage
and V
IN
varied, IN current flow will follow Figure 6’s curves.
I
IN
reverse current ramps up to about 16μA as the V
IN
approaches V
OUT
. Reverse input current will spike up as
V
IN
approaches within about 30mV of V
OUT
as the reverse
current protection circuitry is disabled and normal opera-
tion resumes. As V
IN
transitions above V
OUT
the reverse
current transitions into short-circuit current as long as
V
OUT
is held below the regulation voltage.
Layout Considerations
Connection from BIAS and OUT pins to their respec-
tive ceramic bypass capacitor should be kept as short
as possible. The ground side of the bypass capacitors
should be connected directly to the ground plane for best
results or through short traces back to the GND pin of the
part. Long traces will increase the effective series ESR
and inductance of the capacitor which can degrade
performance.
Because the ADJ pin is relatively high impedance (depend-
ing on the resistor divider used), stray capacitance at this
pin should be minimized (<10pF) to prevent phase shift
in the error amplifier loop. Additionally special attention
should be given to any stray capacitances that can couple
external signals onto the ADJ pin producing undesirable
output ripple. For optimum performance connect the ADJ
pin to R1 and R2 with a short PCB trace and minimize all
other stray capacitance to the ADJ pin.
INPUT VOLTAGE (V)
I
IN
CURRENT (μA)
30261 F06
30
20
10
0
–10
–20
–30
0
0.6
0.9
1.2
0.3
1.5
1.8
IN CURRENT
LIMIT ABOVE 1.45V
Figure 6. Input Current vs Input Voltage
Figure 7. Suggested Layout
1
2
3
4
5
10
9
8
7
6
IN
IN
GND
GNDS
BIAS
OUT
OUT
ADJ
PG
SHDN
30261 F07
VIA CONNECTION TO GND PLANE
C
IN
C
OUT
C
BIAS
R2
R1