MKP 385
Vishay BCcomponents
AC and Pulse Metallized Polypropylene Film Capacitors
MKP Radial Potted Type
www.vishay.com For technical questions, contact: dc-film@vishay.com
Document Number: 28152
164 Revision: 19-Mar-13
Not Recommended for New Design, Use New MKP385
This document is subject to change without notice.
THE PRODUCTS DESCRIBED HEREIN AND THIS DOCUMENT ARE SUBJECT TO SPECIFIC DISCLAIMERS, SET FORTH AT www.vishay.com/doc?91000
MOUNTING
Normal use
The capacitors are designed for mounting on printed-circuit boards. The capacitors packed in bandoliers are designed for
mounting on printed-circuit boards by means of automatic insertion machines.
For detailed tape specifications refer to “Packaging Information”
www.vishay.com/doc?28139 or end of catalog
Specific Method of Mounting to Withstand Vibration and Shock
In order to withstand vibration and shock tests, it must be ensured that the stand-off pips are in good contact with the
printed-circuit board. The capacitors shall be mechanically fixed by the leads.
Space Requirements on Printed-Circuit Board
The maximum length and width of film capacitors is shown in the drawing:
Eccentricity as in drawing. The maximum eccentricity is smaller than or equal to the lead diameter of the product concerned.
Product height with seating plane as given by “IEC 60717” as reference: h
max.
h + 0.3 mm.
Storage Temperature
Storage temperature: T
stg
= - 25 °C to + 40 °C with RH maximum 80 % without condensation
Ratings and Characteristics Reference Conditions
Unless otherwise specified, all electrical values apply to an ambient free temperature of 23 °C ± 1 °C, an atmospheric pressure
of 86 kPa to 106 kPa and a relative humidity of 50 % ± 2 %.
For reference testing, a conditioning period shall be applied over 96 h ± 4 h by heating the products in a circulating air oven at
the rated temperature and a relative humidity not exceeding 20 %.
Eccentricity
I
max.
= I + 0.3 mm
b
max.
= b + 0.3 mm