TC4431/TC4432
DS21424D-page 6 © 2007 Microchip Technology Inc.
3.0 PIN DESCRIPTIONS
The descriptions of the pins are listed in Table 3-1.
TABLE 3-1: PIN FUNCTION TABLE
3.1 Supply Input (V
DD
)
The V
DD
input is the bias supply input for the MOSFET
driver and is rated for 4.5V to 30V with respect to the
ground pins. The V
DD
input should be bypassed to
ground with a local ceramic capacitor. The value of this
capacitor should be chosen based on the capacitive
load that is being driven.
3.2 Control Input (IN)
The MOSFET driver input is a TTL/CMOS compatible
input with 250 mV of hysteresis between the high and
low threshold voltages. If an input signal level of greater
than 12V is applied to the device, a series current
limiting resistor is recommended.
3.3 Lockout Disable (LOCK DIS)
The lockout pin enables/disables the undervoltage
lockout feature of the device. If undervoltage lockout is
desired (output is not enabled until the bias voltage
reaches 8.4V (typical) on the rising edge and is
disabled when the bias voltage reaches 7.7V (typical)
on the falling edge), the lockout pin should be left float-
ing. If operation below 7V is desired, the lockout pin
should be tied to ground.
3.4 Ground (GND)
The ground pins are the return path for the bias current
and for the high peak currents which discharge the load
capacitor. Both ground pins should be used to ensure
proper operation. The ground pins should be tied into a
ground plane or have short traces to the bias supply
source return.
3.5 Drive Output (OUT)
The TC4431/TC4432 devices have individual source
and sink output pins. This feature can be used to adjust
the rise and fall time independently by adding separate
charge and discharge resistors external to the device.
Pin 7 (source output) can source 3 A peak currents into
capacitive loads and pin 6 (sink output) can sink 1.5 A
peak currents from a capacitive load.
Pin No. Symbol Description
1V
DD
Supply Input, 4.5V to 30V
2 IN TTL/CMOS Compatible Input
3
LOCK DIS
Input Pin, Enable/Disable for UV Lockout
4
GND Ground
5 GND Ground
6 OUT Drive Output, Pull Down
7 OUT Drive Output, Pull Up
8V
DD
Supply Input, 4.5V to 30V