Item Performance Characteristics
Category Temperature Range
Capacitance Tolerance
Dissipation Factor
ESR
Leakage Current
Damp Heat
(Steady State)
Temperature Cycles
Temperature Change
Characteristics
Resistance
to Soldering Heat
Surge
Endurance
Marking
−55 to +105
°
C
±20% (at 120Hz)
Refer to next table
Refer to next table
After 5 minute’s application of rated voltage,
leakage current is not more than 0.1CV
−55
°
C / +105
°
C 30minutes each 5cycle
−55
°
C +105
°
C
At 60
°
C 90%RH 500hours (No voltage applied)
Capacitance Change
..
Within −20 to +30% of the initial specified value
Dissipation Factor
.......
200% or less than the Initial specified value
ESR
............................
200% or less than the Initial specified value
Leakage Current
.........
Initial specified value or less
Capacitor meets the following characteristics after solder reflow
(Peak: 240
°
C
for 10sec, 2cycle).
Temperature should be measured at the terminals.
Capacitance Change
..
Within ±20% of the Initial specified value
Dissipation Factor
.......
200% or less than the Initial specified value
ESR
............................
200% or less than the Initial specified value
Leakage Current
.........
Initial specified value or less
Capacitance Change
..
Within ±20% of the Initial specified value
Dissipation Factor
.......
Initial specified value or less
ESR
............................
Initial specified value or less
Leakage Current
.........
Initial specified value or less
Capacitance Change
Dissipation Factor
ESR
Leakage Current
Within −20 to +0%
Initial specified value or less
Initial specified value or less
Initial specified value or less
Within −0 to +50%
150% or less than the Initial specified value
150% or less than the Initial specified value
10 times Initial specified value
After application of 115% of rating voltage at the rate of
30 seconds ON, 30 seconds OFF, for 1000 successive
test cycles at 105
°
C, capacitors meet the characteristics
requirements listed below.
Capacitance Change
...
Within ±20% of the initial specified value
Dissipation Factor
.........
200% or less than the Initial specified value
ESR
..............................
200% or less than theInitial specified value
Leakage Current
...........
Initial specified value or less
After 2000 hours’ application of rated voltage at 105
°
C, they will meet
the specified value for life charecteristics listed below.
Capacitance Change
....
Within ±20% of the initial value
Dissipation Factor
.........
200% or less than the Initial specified value
ESR
..............................
200% or less than the Initial specified value
Leakage Current
...........
Initial specified value or less
Printed on the package top.