113990296

LoRa/GPS Shield For Arduino
SKU 113990296
Description
The LoRa/GPS Shield is an expension board for LoRa™/GPS for using with the Arduino.This product is
intended for those interested in developing LoRa™/GPS solutions.The LoRa/GPS Shield is composed of
LoRa/GPS Shield mother board and LoRa BEE.
In the LoRa part,the LoRa/GPS Shield is based on the SX1276/SX1278 transceiver.The transceivers of the
LoRa/GPS Shield feature the LoRa™ long range modem that provides ultra-long range spread spectrum
communication and high interference immunity whilst minimising current consumption. LoRa™ also provides
significant advantages in both blocking and selectivity over conventional modulation techniques, solving the
traditional design compromise between range,interference immunity and energy consumption.
In th GPS part,the add on L80 GPS (base on MTK MT3339) is designed for applications that use a GPS
connected via the serial ports to the arduino such as timing applications or general applications that require
GPS information.This GPS module can calculate and predict orbits automatically using the ephemeris data (up
to 3 days) stored in internal flash memory, so the shield can fix position quickly even at indoor signal levels
with low power consumption.With AlwaysLocate™ technology, the LoRa/GPS Shield can adaptively adjust
the on/off time to achieve balance between positioning accuracy and power consumption according to the
environmental and motion conditions.The GPS also supports automatic antenna switching function. It can
achieve the switching between internal patch antenna and external active antenna.Moreover, it keeps
positioning during the switching process.
Frequency Band: 868 MHZ/433 MHZ/915 MHZ(Pre-configure in factory)
Low power consumption
Compatible with Raspberry Pi 2 Model B/Raspberry Pi 3.
LoRa™ Modem
FSK, GFSK, MSK, GMSK, LoRa™ and OOK modulation
Preamble detection
Baud rate configurable
Built-in temperature sensor and low battery indicator
Excellent blocking immunity
Automatic RF Sense and CAD with ultra-fast AFC
Support DGPS, SBAS(WAAS/EGNOS/MSAS/GAGAN)
GPS automatic switching between internal patch antenna and external active antenna
PPS VS. NMEA can be used in time service
Support SDK command
Built-in LNA for better sensitivity
EASY™, advanced AGPS technology without external memory
AlwaysLocate™, an intelligent controller of periodic mode
GPS FLP mode, about 50% power consumption of normal mode
GPS support short circuit protection and antenna detection
LoRa Spec
168 dB maximum link budget.
+20 dBm - 100 mW constant RF output vs.
+14 dBm high efficiency PA.
Programmable bit rate up to 300 kbps.
High sensitivity: down to -148 dBm.
Bullet-proof front end: IIP3 = -12.5 dBm.
Excellent blocking immunity.
Low RX current of 10.3 mA, 200 nA register retention.
Fully integrated synthesizer with a resolution of 61 Hz.
FSK, GFSK, MSK, GMSK, LoRaTM and OOK modulation.
Built-in bit synchronizer for clock recovery.
Preamble detection.
127 dB Dynamic Range RSSI.
Automatic RF Sense and CAD with ultra-fast AFC.
Packet engine up to 256 bytes with CRC.
GPS Spec
Based on MT3339.
Power Acquisition:25mA,Power Tracking:20mA.
Compliant with GPS, SBAS.
Programmable bit rate up to 300 kbps.
Serial Interfaces UART: Adjustable 4800~115200 bps,Default: 9600bps.
Update rate:1Hz (Default), up to10Hz.
I/O Voltage:2.7V ~ 2.9V.
Protocols:NMEA 0183,PMTK.
Horizontal Position Accuracy:Autonomous <2.5 m CEP.
TTFF@-130dBm with EASY™:Cold Start <15s,Warm Start <5s,Hot start <1s;TTFF@-130dBm.without
EASY™:Cold Start <35s,Warm Start <30s,Hot Start <1s.
Timing Accuracy:1PPS out 10nsReacquisition Time <1s.
Velocity Accuracy Without aid <0.1m/s,Acceleration Accuracy Without aid 0.1m/s².

113990296

Mfr. #:
Manufacturer:
Seeed Studio
Description:
GPS Development Tools LoRa/GPS Shield For Arduino
Lifecycle:
New from this manufacturer.
Delivery:
DHL FedEx Ups TNT EMS
Payment:
T/T Paypal Visa MoneyGram Western Union

Products related to this Datasheet