03$
PI5C34X2245
32-Bit, 2-Port BusSwitch
with 25Ω Series Resistor
Storage Temperature ............................................................ –65°C to +150°C
Ambient Temperature with Power Applied ........................... –40°C to +85°C
Supply Voltage to Ground Potential .......................................–0.5V to +7.0V
DC Input Voltage ....................................................................–0.5V to +7.0V
DC Output Current.............................................................................. 120 mA
Power Dissipation ................................................................................... 0.5W
Note:
Stresses greater than those listed under MAXIMUM
RATINGS may cause permanent damage to the
device. This is a stress rating only and functional
operation of the device at these or any other con-
ditions above those indicated in the operational
sections of this specification is not implied. Exposure to
absolute maximum rating conditions for extended periods
may affect reliability.
Maximum Ratings
(Above which the useful life may be impaired. For user guidelines, not tested.)
DC Electrical Characteristics (Over the Operating Range, T
A
= –40°C to +85°C, V
CC
= 5V ±10%)
Parameters Description Test Conditions
(1)
Min. Typ
(2)
Max. Units
V
IH
Input HIGH Voltage Guaranteed Logic HIGH Level 2.0
V
V
IL
Input LOW Voltage Guaranteed Logic LOW Level –0.5 0.8
I
IH
Input HIGH Current V
CC
= Max., V
IN
= V
CC
±1
μA
I
IL
Input LOW Current V
CC
= Max., V
IN
= GND ±1
I
OZH
High Impedance Output
Current
0 - A, B - V
CC
±1
V
IK
Clamp Diode Voltage V
CC
= Min., I
IN
= –18mA –0.7 –1.2 V
I
OS
Short Circuit Current
(3)
A (B) = 0V, B (A) = V
CC
100 mA
R
ON
Switch On-Resistance
(4)
V
CC
= Min., V
IN
= 0V, I
ON
= 48mA 28 40
Ω
V
CC
= Min., V
IN
= 2.4V, I
ON
= 15mA 35 48
Notes:
1. For Max. or Min. conditions, use appropriate value specified under Electrical Characteristics for the applicable device type.
2. Typical values are at V
CC
= 5.0V, T
A
= 25°C ambient and maximum loading.
3. Not more than one output should be shorted at one time. Duration of the test should not exceed one second.
4. Measured by the voltage drop between A and B pin at indicated current through the switch. On-Resistance is determined by the lower of the
voltages on the two (A,B) pins.
Truth Table
(1)
Function BEn A0 – 31
Disconnect H Hi-Z
Connect L B0 – 3
Notes:
1. H = High Voltage Level, L = Low Voltage Level
Hi-Z = High Impedance
Pin Description
Pin Name I/O Description
BE
X
I Bus Enable Input (Active LOW)
A
0
-A
31
I/O Bus A
B
0
-B
31
I/O Bus B
06-0238
